Search results

It looks like I'm going to have a problem. This morning the glow plug light only came on for a fraction of its usual time. Car turned over and started ( lumpy) but cut out after a couple of seconds. Did it a couple of times then ran. There is no smoke or steam on start up either Has started and...

Evening everyone. I have a current problem with my drivers side front leccy window. If you do the "one touch down" it comes completely off of the toothed qaudrant ( the end is chewed and worn). I know it'll need reolaced but in the interim I wondered if the one touch down could be disabled by...

As the post says really. Given the price of key fobs for lowering the suspension and picking up a trailer or caravan on the tow hitch ( or even getting it in though the garage door thats just that wee bit too low) how usefull does the collective think a self contained set up would be if it could...

Well I thought my landy was leak free. Untill a downpour last week showed water ingress. BUT it was parked nose up on a steep hill so Ithought "OK the roof drains are at the front so it'll be water running over the back of the drain tray" So I started parking it nose downhill and all was OK till...

Evening all. I have a cyclic/pulsing noise/vibration coming from the rear of my disco. It comes in at around 57mph and goes after about 70mph ( sometimes). Its worst at full throttle acceleration and goes away if you lift off. Similarly if you take it up to 70mph and let it slow down or dip the...

Hi guys I'm about to undertake welding to the front wheel arches ( inner) where the rot has taken hold under the plastic guard. I will need to remove the battery and fuse box/expansion tank etc to get at the rot as well. As the battery and ecu will be removed is there anything that's going to...

As the title really is there anyone/anywhere that does a reapir patch panel for the front inner wings of a disco 2?? What are the MOT implications of holes in this area?. Its the area between the plastic arch shield and the wing that's gone in a couple of places on both sides. Thanks in advance...

Well folks after years of hankering after a 110 CSW which was going to be overland prepared ( just because I could not for actual overland) I have reasoned that I do not have the room to do it ( yet) s. So after looking at 90's and 110's for so long I am tempted to the disco side. It's very much...

Hi folks just a quick hello from a newbie. I aspire to own a 110 CSW and am currently looking at one close to home. Its a pretty fresh ( no chassis welding) G reg but it has the turbo deisel in it ( 19J ):frown:. How big a problem is it? I'm told it will be painfully slow?. The inside is gash...