Search results

Hi all, I have just acquired a '96 300 tdi manual i think the injector pump is duff, any thoughts much appreciated: Going to start it in a morning it fires instantly and runs as sweet as a nut, if you give it full throttle nothing happens!, after ticking over for 3 or 4 mins it will rev but...

Hi Guys, long time no see!! believe it or not I have had almost a full year of problem free motoring from the rangy and the disco....however..... got a very strange problem with SWMBO Td5 went to it yesterday pressed the blipper and it unlocked, I drove down the road and realised I had no...

Hi all, bless her she's collapsed on one side Fire her up and all four corners lift but not level drivers side is low front and rear looks like drivers side is normal and passenger side is in wading mode, if you let her down to access mode she goes down but again unlevel, turn the key off...

Hi all, got a weird one here, p38 2.5DHSE, driving to the local shop saw smoke coming from the front offside wheel, pulled over the wheel was red hot, left it for a few minutes when i went to pull away she was going no where in drive foot down nothing!!! finally got it home swopped the calipers...

Hi all, got a really odd problem with my p38 1998 2.5dse the suspension pump will not run unless i connect a 12v feed to the purple/light green cable feeding it, the timer delay relay appears to be working and there is voltage going to the ecu, but there is NO trigger voltage though to R20 in...

Hi All, got a p38 dhse, pulling away and acceleration is really awfull (worse than normal) changed all the filters inc auto box filter, starts and runs perfectly free revs no problem but wont pull away, the upshift is also very slow, only fault code coming up is the IAT sensor would this cause...

Hi all, got me a problem.... my 300 tdi has snapped the rocker shaft stripping the thread on the rear bolt, upon inspection i see that it has been helicoiled before obviosly an M8 1.25 helicoil wont do the job so i wondered if there is any way around this without scrapping the head. hope that...