Search results

sold stc

Thside steps I had blasted and to be painted I purchased another set to repair the original I also have all the plastic covers,the ladder has a rusty rung and one missing but it's only small box I may have some,and the bumper has paint peel on the underside but has the hole,s for the end caps...

4x boost alloys most preped for painting one already painted satin black £160 SOLD Sorry

sold sold sold

I'm trying to source the diff output shaft seal sizes as I want to replace them with viton seals many thanks Rob

evening all i have just purchased a disco 2 with the amber ace light on i have pluged it in and have the following codes 0023 pressure signal out of range, 0033 direction control valve fault, 0041 hydraulic pressure too low. Any ideas I'm thinking ace pump or perhaps oil and filter change ??

Im looking to put on some spacers on,i have been looking at 30mm bulldog spacers but im not shure if hub centric are the ones to go for I think they would support the wheel better but im in need of some advice cheers

Does anybody know what dual mass play tolerances are i.e side play rotation take up im assuming all dual mass flywheels checked in the same way.

wanted 30mm wheel spacers for defender

defender 90 Galvanised roof rack and ladder £85 ono south wales in good condition slight damage on on side.

Well here goes I have an nnn ecu of a customers disco and was looking to have a go at repairing it and fit it to my defender so I can tune it. from what I remember their is outputs from the ecu does anybody know what fails inside the ecu I have had a visual inspection nothing that I can see...

Im going to rebuild the diffs on my defender so I would like to try and source the bearings cheers rob and its a 90 built in 99

Finally got round to fitting the x member supplied by Clive at black sheep offroad I must say excellent service and well made not to forget damm strong. I did it without removing the tub floor ,but its made easier on the ramp removing the tank was a pain putting it back was just as bad anyhow...

Im looking to purchase nanocom for the future to aid fault finding etc just wondered if the code injectors cheers.

Is this autojumble event worth going to as im new to the landrover show scene ,or can anybody recomend shows that are good for spares and entertainment cheers Robin.

Have been looking for a roof rack but can't find one for the right money,has anybody got the matec roof bars if so are they worth the money and are they good quality cheers

Does anybody have a pic of where the door electrics are feed from as im fitting central locking and want to know where landrover route it i have some rubber gators to protect the cables.

Looking to replace my rear door its a bit rotten Cheers

Has anybody fitted a heater Pre heater to a defender td5 ,looking to fit some sort of heater to speed up the in cab heater process especially on the cold mornings. I have been looking and Citroen Pre heaters.

After ringing around company after company, I settled with the nfu very helpful and very competitive and a good level of cover I thought also no overseas call centres. I was with hic which I think is the sister company to adrian flux and the renewal was £553. Im 35 full ncb and my wifes on...