Search results

Thanks to all. Never had a problem with the injector light previously. She just would not start one morning, no fuel bei g injected. Checked pump output, flattened two batteries, changed and synced the ecu on the engine, no start. Stop solenoid clicking. Changed cps, flattened two more...

Hi yes it also says fuel flow value out of range

00ps 93 degrees water temp that is

98 diesel auto, had problems with her not starting but she starts OK cold or warm now. however took her out on the road today and she cuts out ar Nything over 2750 revs. I. E. Engi e stops have to pull in restart her, starts no problem. Will rev freely, hold 2750 and above when in neutral or...

Many thanks

A other fip pump I take it then?

So that's a fip change?

Hi I'm in Caerphilly and I terested

Nanocom says timing modulation is 48. The injector light flashes when I rev to 2000, it flashes on the return. If I rev to over 3000 it falls back OK and no flashing injector light. Oh forgot to say it has a rock solid idle of 750 at warm idle. Nanacom records major fault intermittent, I guess...

Hi I'm in Caerphilly, is she diesel, many thanks oh and how much are you seeking, Thanks

Doubt it was an airlock as I flattened the battery four times and used the hand primer to get fuel to the fip. Might be a wire but I've pulled, wiggled, woggled all I can see and she still starts spot on cold and even hot.

Apologies BIG THANK YOU TO ALL WHO SO KINDLY REPLIEd

Update Changed the cps, no joy. Rechecked the pump output after the filter head with just turning the ignition. On, 200ml about Decided to remove filter and check output 200 ml so filter OK I assume. Screwed filter back on. Watched the clear pipe as a mate turned it over. Hey presto slackened...

Only thing I've done with the nanacom is plugged it in, switched it off then removed it. I'm too frightened to get into the becm in case I made a mess of changing anything. Can the crankshaft position sensor be checked with an Ohm meter as I'm always cautious of connecting the sensors to one in...

update Fitted a fully charged 1000 cca battery and i collected the diesel after the filter head,when the heater plugs operate 180 ml were collected if i bridge the relay out in 20 seconds i collect 300 ml so i think the in tank pump is working ok no air can be seen in the clear pipe The...

Hi all thanks for the replies but still a non starter Nanacom says no faults in the becm. I have alive feed with ignition on to what i would call the stop solenoid so can i take it that the engine ecu and becm are synced as the syncmate says they are. Sniff of easy start and she will fire but...

Hi all, 1996 diesel auto p 38 this morning the ole girl wont start. Turns over but wont fire no red led flashing on top of dash. when you turn the key the heater plug light comes on as does the injector light which then goes out. She turns over freely. I've locked her with the fob and unlocked...

i fitted a new stat when i fitted the new rad,viscous etc ,it had a hole with a ball bearing fitted which i imagine is some sort of one way /air bleed valve. She used to sit at about 11 oclock and you can see the water flow when the stat comes in as the needle rises then falls. she usually gets...

Yep the rad has a baffle,checked before i fitted it . The rad out hose gets hot and the other is a lot cooler so i think the rad is doing its job