Search results

Never tried… they may fit early shafts How do the series ones hold on? At least the plastic ones grip a lip

@MGT have you seem the trouble you have caused… Having to ignore this thread is causing sleepless nights. Off to the doctors to see off they can help.

Had a look as busy tommorow. There calendar is good. Waiting to see where the September meet is. Been to caffeine & machine a few times which is a good meeting point & the food is good https://www.teaonthetailgate.co.uk/

Find out when… (Dont do FB)

They should be nuts & bolts. They are not captured Grind the heads that you can see off & push the remains out the rear

Oh I thought I was the only 1 ignoring it

The valves would bend on impact so would not cause damage. Normally if a belt/chain goes it would mark a few pistons not all of them Have you had any head problems?

I thought you would have upgraded the glass fuses. ( I do have the glass fuses and they can be finicky but are easily sorted)

You forgot skin tight Lycra. Plus on a bike you don’t stop for traffic lights

Should I remove this thread from my watched selection?

How many can weld to the BS5135 spec? ;) Great info though

That’s blown the hub seals. Check your breather pipe on the axle to see if it’s blocked . Check the bolt itself as well. I know you say you checked them,can you blow through the pipe? It’s unusual for the seals to go.unless you had cheap ones fitted and they gone brittle with lack of use

Think all measurement are from the rear tub as this is a fixed point & can’t move. Unsure of the measurements between tub & bulkhead(door gap) Bolts for bulkhead correct way,you can put a jack under the bulkhead & remove bolt back a bit to allow shim washers to go in the gap.

Think You can get lockers that are assessable above the wheel arches.

Once you agitate the rubbers they come apart. The connections are tight

At least been the nominated driver you always get a comfy seat. Nuts to the others & let them battle over the crap seats

It should be a block connector into the loom

You changes the air filter as well?

It’s so when the nick your doors at the next landrover show,you can go back to the campsite for spares

@tyregeezer doing some good work there and informative. Nice to see how these motors are built & repaired @gstuart keep the faith…