Search results

No problem welding it, Just have to find where to make the cut. It's just that it has unwanted old screw holes in it and being bent, you never get it straight again unless you are an epert. A new piece of steel would look so much better. I just wondered if it had been done by anyone.

This one in the middle.

I mean the flat panel that is curved at the bottom which the transmission tunnel bolts to. It has I believe the hole for the hand throttle.

Hi folks, Has anyone changed the bulkhead curved centre panel, the part between the footwells over the gearbox. Apart from being bent up at the bottom it has lots of holes and self tapping screws through it. I thought it might be easier to replace it than weld all the holes up and straighten it...

Cheers for that. I am nowhere near that position , I am just fitting a new footwell and wondered what all the holes were for. Any un-needed ones I was going to weld up. My son took the Landy apart about 7 years ago now, etc. left it to me and my other son to rebuild. lots of new bits including...

Hi Folks, Anyone know what the 4 horizontal holes are for in the lower part of the passenger footwell? Cheers Peter

Series 3 1983. I have been lining up my replacement YRM nearside footwell. It fits perfectly. Only problem is that the bottom flange that it gets welded to is near rotted away or paper thin and will need chomping out,

Started trimming a piece of metal to fit into a hole on the series 3 bulkhead. Then trimmed it a bit more etc etc, then went in for tea before going up the pub.

Worn distributor shaft?

When making it . It was a case of cutting a rectangle of plate, making two bends then make two cuts, bend again cut a bit out, weld together, and weld a bit in. Drill two holes and cut an opening. Easy...............I don't think. It was a pain to make. C'mon other restorers,How did you do it?

That is the offside piece the nearside was completely rotton. I made a replacement for that side, just wondering if they are made anywhere.

Hi. this was taken from the inner top corner of the bulkhead. I have never seen them mentioned on build threads or on Youtube. I cant find them online to buy, I had to fabricate my own. What have the bulkead restorers done about them? cheers peter

Welcome . First rule is..........lots of piccies

Stick em back

1983 Series 3 88 Started work on the rusty port (sorry) near side bulkhead pillar and floor, which saw me getting excited with the angle grinder. Pics to follow in a couple of weeks ....I think.

I made a cardboard template, made a new section, it needs a couple of holes drilled and will be trimmed after fitting. Then cut out the bad stuff and will try fitting over the next day or so.

I cleaned down to bare metal, redrew my marks , tacked on the hinge and snugged down the bolts and it swings easy

I just checked my original mark and it measured 1406 mm so that looks fine. My son is coming around later and will help me try the windscreen and bolts/brackets for position ( too heavy on my own). Will see how near it is, cheers for the help Peter

Thanks Tott

Sorry, they are the screen brackets that sit up above the top of the bulkhead.