Search results

When you have refilled it in the past what method have you used? Refill engine off? Refill, then top up with engine running🤔👍

I want a lady garage as well😝

I'd be checking around the air tank to make sure the air supply to it hasn't been popped off? A good clean up needed then and a thorough examination of air lines and airbags. 👌

Just be careful the thread isn't stripped out of the aluminum bracket. A dab of thread locker or Loctite on the bolt and it should be OK 👍

Check the tightness, a lot of the big Landy stuff needs to be vain popping tight. Especially on the multi link stuff 👍

Maybe loosen it and faf with it a little. The proof will be when you warm the engine and check your work👍 Are you sure the o-rings are correct for the application? 🤔

As long as the collars on each pipe sit against the black plastic they are are home. The aluminum collar should be sat equally across the pipes in relation to the black plastic receiver 👍

Ooer, I'd of thought the end bearing will be around 2" in diameter. Unless you fill it with JB weld just to fend off a leak😱 You may have to put it together a d monitor it... 🫣

That's a result😎

But you'd have a fault warning on the hevac for blend flap🤔

Have you got the little "book" warning sigh on the hevac heater until display?

Ooh, that's a good one👍

I've got one of those for the Volvo, it sounds good. About 30€ from Amazon 👍

Not copper grease my mate and only if its silicon grease not sealer! 🤔. If you don't have any other grease, wet the oring outer surface which will allow them to slide in while fitted on the pipe end.

I simply swapped the radio for a modern unit, gaining the microphone for calls as well and then traded the old unit for some bits. There is a mod on the YouTube that is a little more involved than I wanted to be. 👍