Search results

If there's play it's an issue, whether or not it's "the" issue my good man. 🤔👍

Well spotted that man👍

It's quite likely the rubber leak off pipes are split at the ends. If not and it's the fourth injector, the seal around the wiring on the injector can give up and a new one needed😬

Around 432.000kms🤩

That's miles my dear😘👍

Upwards and onwards☝️😎

Yip, the outer track rod end, the inner track rod end. A longish bar with a ball joint fitting that screws into the rack end. 👍

That's an idea 😂 It may be easier to remove the inlet manifold to get to the inner coller nut on the pump and there is the support bracket at the rear lower part of the pump that may need loosening up... It's been a while since I did one🤔

You have your outer ball joints and the inner bar with a ball joint on the end. As you know but the rack itself can develop play internally and I hope that isn't the case. What is the power steering fluid like?

Thread will undo when turned to the right. The trick is to get the big 36mm spanner over to the left as far as possible and smack it with a hammer towards the right. It will eventually shock it loose. A touch of copper grease on refitting with a couple of good taps towards the left👍 Also check...

Jeez, the head of the pump should be moved towards the engine block or if sat in the car, clockwise👍

You like your excel don't you🤔😜

The only issue is getting the old bearing out as they take a bit of force if old and original. I'd bought some blueprint units and found one had failed after two years😵 I then bought an SKF bearing and used the blueprint outer casing and an original land-rover wheel hub. I found the blueprint...

It sounds like it's not getting fuel. Is the in tank pump working? Have you checked for spark? I'd go back over the work to see if anything has been overlooked 🤔 Did it run OK before the repair (apart from the original issue)?

Ooh, I had that happen to mine and a little liquide had seeped out onto the center dash... It's like bloody acid🤯

Two screws inside the cubby box, these will allow you remove the panel and go from there🤔

Also compare the old and new bushes. You could been supplied the wrong ones🤔

There should be a thick washer on both sides. Arm=washer=bush =chassis. Chassis=bush=washer =nut👍

I'd agree with the handbrake stopping any movement 👍 Mine do have a bit of slack after 269k but I'm not surprised 😛

Noted babe😘