Search results

...my hope was that the switch pack was not receiving any voltage - but pin 1 supplies 12 volts, so the switch pack has power. I am completely at a loss. Yes, I'm working on the nanoncom - but not until the end of august. what really doesn't leave me in peace is that i got it to work again...

...have now measured at the plug: 1 - 12 v 2 - 5.28 v 3 - 5.28 v 4 - 5.28 v 5 - 63.9 ohm 6 - 24.4 ohm cannot judge it in any way. The plug at the bottom (marked red) has 12 v on both wires

ok, thanks, I didn't know that. i'll now remove the switch pack and check whether 12 volts is being supplied to the plug.

the first in the fuse box - that is responsible for the switch pack - I think.

Hello everyone, I started locating the problem today. I noticed the following right at the beginning: Ignition is on level 2 1. I get 12 volts at the fuse at the top and bottom 2. then I take the fuse out and I go directly to the "metal bracket - I mean these metal slots" - there I get 12...

ohhh, the whole only exists as a unit! Very expensive! Can it be removed and repaired? Has anyone ever done it? ALR6955 FQJ103250 Thanks!

...yes, it sounds like the gears are defective. is this a unit that needs to be replaced? the motor seems to be riveted? How do I get it replaced? Thanks!!

Good evening everyone, For the last 3 weeks I have had the problem that when I press the button to open the car, all the doors open - except the driver's door. The key works, the handle works and pulling up the pin manually also works. There is a loud whirring noise - from the motor in the...

yes, that sounds absolutely conclusive. i'll check it in great detail tomorrow!

no, everything is dead on the switch pack. it must be the fuse - the first one is also responsible for the switch pack.....if I understand correctly...

...but how likely is it that all contacts in the switch pack will fail at the same time? I've watched this video but I don't think it's my problem.... not a single button on the switch pack works. When it worked briefly, all the buttons worked.

Good evening everyone, I have put everything back together again today. I also ordered new fuses and replaced them today. The complete switch pack is still without function. I mean, what should I do now? The cable from the switch pack is fixed - I've already checked that. The fuses are also...

pwood999 - thank you very much! That worked out great - the windows are closed and I now have peace of mind and can prepare everything else in peace. This was my setup: I quickly built 2 plugs

thanks! but how should i proceed? plus on the 1 and minus on the 2? then plus on the 1 and minus on the 3? .... i have now checked all the PDFs but nothing says how to trigger it. I phoned my LandRover dealer today - the next available appointment is in 8 weeks! Everything I do - is at my own risk!

Thank you. The question is, how can I switch off the window regulator? I would like to disconnect the car battery and trigger the whole manual with a wire. In other words, energise the motor of the window regulator.

I have another question. For a long time I have had the problem that when I open the car on the remote control - all the pins go up - only the one on the driver's side stays down - but you can clearly hear the motor running. As I took the panelling off for the first time today - I could...

Thank you, I have read the Electrical Troubleshooting manual pdf. But it doesn't show the plug from the motor - but the individual plugs - I don't understand anything about that. Here page 249 - I think...

I can try it out - is it always plus cable at the top and then minus at the bottom?

I have found the Electrical Troubleshooting manual pdf - but I don't understand it...

my PDF only has 1360 pages?