Search results

Hi, I have a copy of rave, your help would be greatly appreciated again :-), hoping this will allow me now to get to the bottom of my rumble issue. Help away :-)

Hi all, Well transfer box now fitted with CDL and refitted, however, I don't seem to have any connectors in the vicinity for the cdl switch? It's a 53 td5 s, any ideas?

Still ongoing at the moment I'm afraid. Fitting a transfer box with difflock so I can lock out the drive and try whittle it down. Shall revert :-)

Guys outstanding help. Shall get ino it and revert. Thank you all so so much.

Correct sir, transmission ecu. Don't suppose anyone has a drawing for this part of the loom to the transmission ecu. I would be willing to check this first, then the service, then the transmission ecu, lastly gbox replacement.

Hi guys will do, I'll order the above. Just another thought, as one solenoid is showing voltage and the other isn't, does anyone think it may be worth a module change? Trying to fix in the most economical way. Second hand working module £20, service kit and oil £44 recon box and torque converter...

Gents, all input is massively appreciated. She is parked up firmly till I can figure this out. I will order a service kit, to include oils and filter. Yea she is firmly locked in limp mode, so no going through the gear range. As soon as I clear the faults, the flash greens go off for around 20...

Hi, Yea, lol, can be blonde at times but not that blonde. Low oil wouldn't give a solenoid fault as far as I'm aware? I may be wrong?

Ok so here are the exact descriptions from T4: Solenoid valve 1 monitoring (sc to gound or o/c) As above for no 2. Next page Short to ground or open circuit. Fault is present Continuous fault Freeze frame Engine speed = 0 rpm Voltage at solenoid 1=0.0v Battery voltage = 12.041v. All is...

Does anyone know if the automatic valve block internals of the v8 box will fit into a td5. Low mileage gearbox expensive, v8 cheaper, was just going to swap the valve pack over.

Does anyone happen to know the OD size of the discovery 2 airline / pneumatic pipes? Got a leak and want to patch. Thanks again all.

Just my opinion, DLS screwed me around terribly. Parts didn't arrive, then bits lost. Better to order the parts separately.

Many thanks for the help, on another note, does anyone know what size of airline / pneumatic piping is used on the disco 2. Also got a leak as I found today. Thanks for the assistance.

I have a disco 2 with an auto box issue. Got it at a steel of £2k for an es td5 facelift with a known fault. The two gear lights are on and it is in limp home mode. Plugged in the diagnostics and it says solenoid 1 and solenoid 2 faults. Is this a new box job, don't mind so much if it is. As its...

I shall take a look, the casing is relatively new, done by the previous owner, shall check and revert, thanks

I don't honestly know? Prop just bolts to the hand brake drum. Don't suppose you have a picture or a microcat picture of what I should be looking at

Hi folks, mounts etc were looked at, garage (independent specialist) said those and the gbox mounts were ok. Props were checked. All passed muster. New wheel bearings front and new brakes all round. Rear bearings to be done this weekend but the old ones run nice and smooth with no rumbling or...

Hey bud, thanks or that, I have had two differing sets of wheels on and no change.

Ok so an update, both front hubs changed, wheels all balanced, new rubber coupling. Still no better. Help! :-)

Bloody iPad, gearbox lol