Search results

are you a bit jeff or you motor too loud?;) I suppose you could hook a buzzer up to the output of the blinker unit for the indicators. buzzes in sync with the flashing of the indicators.

Think I can help you, as I've just been tinkering round this area. your green wire should have a black stripe on it and your white should have a light grey (slate) stripe. the black is ground (chassis earth, battery negative). green goes to your gauge, black goes to anywhere on the frame and...

well if you ca get a Nc switch in the sill of the door, you could connect it to ignition live and then to the buzzer +ve. so if your ignitions on and you open the door, the buzzer will sound. but seen as 75% of the time we turn off the engine then open the door, by turn off the ignition will...

CommsBlog Adding a Headlights Warning Buzzer to my Series III Land Rover little project to add a buzzer to your SIII to make sure you don't forget to turn your lights off.

if I had to guess, it'd be #15 or #7 on that drawing, what part numbers are they?

will have a goosey at the breather first, no play in bearing, went trailing ons sunday and scrutineer would have pulled me up on it.

The White Zombie Summer 2010 Compilation on Vimeo could be useful if you could get that motor in a trailer!

Fluid's started leaking out of the drivers side rear axle, as the inside of my wheel is coated in a tie-die pattern of the stuff. Its definately not brake fluid as its sticky-er than DOT-4 and my brake fluids not gone down. I pretty sure its EP90 (smells and feels like it) I think need a...

check there is voltage to the pump: crack out your multimeter turn on ignition and check the feed to the pump. if no voltage, check fuse for fuel pump (consult manual for which fuse it is). Replace with same rating if blown. Turn ignition, if pump still not whirring, check fuse again. If it...

might be worth the price if your breaking it for bits!

replaced panahrd with one, with new bushes. replaced a track rod end welded up a bit of my chassis found out a fuse had blown for RHS side lights, replaced fuse, all working now

....your missing a trick....supply and demand!

probably the same bloke who was called out to look at me missus motor, some sort of rattling, his fix was "....turn up the radio so you don't have to hear it..." .....£100 well deserved... ....not

sound sensible, check the cheap and easy stuff before going at the big expensive stuff. ok so next 2 questions: can anyone point me toward an overhaul kit? (if I need it) where exactly is the starter solenoid under the bus? just so I don't start pulling cable out of place I don't need to be...

me 200tdi's not been starting right for a few weeks, go to start it and "click", thats it. it eventually starts after a few attempts. I think the starter solenoids going, so I wondered can I repair/overhaul/tinker with it to get a bit more life out of it, or is it a replacement job...

well bugger me with a fish fork! thats a prime example building something ugly, very well!

fianlly fixed fuel sender unit! now no longer reads full all the time

this has been fixed: float had a pin prick in it and fuel got into it, making it sink to bottom, thus shorting the float arm to the unit case, hence reading full on gauge. Removed float, found pin hole and drilled it, then drilled another hole in end of float to get fuel out of it. fitted it...

seriously, why you trying to get up to 75mph....60's all i can do with a 200tdi, plus I like I like my drivers license & i like my insurance to stay low.

where you late for work or something?