Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. T

    Key Fob Problem

    The new key should come already programmed to your car no extra programming is possible,when the key is ordered it is done to chassis no bigstoo is correct you should have given your car docs over and a new key would be cut and programmed to your car this is as long as it has not had a previous...
  2. T

    Starting Problem??

    Hi if your battery drops to 8.5 volts on crancking it is to low should not really drop below 10v,have you tried putting another earth wire on it or just using a jump lead on a good earth to check it does not need another earth strap i have read you have done this but best to check as the 300...
  3. T

    Hello

    hi andymac enjoy the site its a laugh,tiga and sometimes you can get good advise,ha ha ha
  4. T

    300tdi power problem

    HI have you checked out all turbo pipes,i fitted a non genuine lift pump to a 200tdi the other day and it did not lift enough fuel up as the arm was bent at an incorrect angle,its just an idea to check out,most of the time a 300 will rev alright to about 3k then run out of power due to fuel...
  5. T

    range rover 4.0 se auto box fault

    hi just a question will it start in nuetral or is that a no no,it could be the H gate electrics playing up or the switch on the side of the gearbox,tiga
  6. T

    P38 Niggles

    Hi it seams you have the correct answers already for outside air temp and hot start fault,the high/low range fault could be just bad connections on ecu for transfer box which is located under passengers seat,just make sure all pins have a good contact,from memory if you place a fuse in slot 11 i...
  7. T

    Need some info and Help

    Hi just looked on rave rocker pedastal bolts are 5 Lb ft +50 degrees and tappets are listed as 10 thou but everybody i know does them at 8 thou as they rattle to much at 10 thou hope this helps get in touch if you need anymore info cheers tiga oh and your dads car is a turbo disel 5 cylinder...
  8. T

    Help Needed Please

    It sounds like a water leak problem for heater to go cold check water pump gasket area and water pump housing gasket area any water rusty stains down right hand side of engine at front,if you find leak take off top small pipe to thermostat housing check to see if water comes out when engine...
  9. T

    Disco 3 problems

    Hi i must say that recently new software has come out to fix CERTAIN GLITCHES shall we say and thay do appear to be working for most,why is it that these geeks that get paid far more than i can dream of getting cant write a blooming programme that will talk to every ecu at the same time in the...
  10. T

    night smoke

    Hi ithought it was that special mixture i was burning but nope still does it on the expensive stuff,tiga
  11. T

    Problem starting from cold

    Dont be silly easy to change the filter,its in the right hand side of engine bay,remove top hose clips back far enough to twist pipes off undo 8mm bolt holding filter in bracket put in new filter and put pipes on the right way round there is an arrow on top for dirrection of flow then tighten...
  12. T

    S2 V8 Ecu Not Reading O2 Sensors?

    No problems please let me know if i can do anymore,1 thing that just come to my mind is make sure that the car has not lost its market programming i have seen this before on a TD5 they changed the engine and it would not start when i looked through the car configuration files it was listed as an...
  13. T

    Td5 Rear Suspension

    you need to spray right around the top of the ring were its fixed as this area can be overlooked,which side goes down or is it both if its both sides i would say check at compressor end to make sure exhaust valve is not leaking hope this helps,tiga
  14. T

    S2 V8 Ecu Not Reading O2 Sensors?

    Hi reading the rave disc at the engine ecu there should be a 24 pin connector which controls the oxygen sensors at at least 4 of these pins there should be 0-5 volts reading changing with differing temps at sensors, pins 14/15/16/17 all 0-5 volts,if the car is not programmed to the correct...
  15. T

    Disco 2 Clock back light

    Hi an easier tool i find is those spatulers you use for filling holes in the wall with poly filler plus its got a handle on it so prise out easy,also you dont damage your credit card,tiga
  16. T

    S2 V8 Ecu Not Reading O2 Sensors?

    hi had this fault on a p38 range rover import but that was due to not having cats fitted as not needed in aussie but failed its mot over here,not come across on a disco it might be possible to turn the sensors on if ecu does not reconise them,did it run ok before, when did the fault start was it...
  17. T

    Central Control Unit

    hi you can also check the connections at the ccu if you look at passenger fuse box take off cover the right hand side has 3 connectors on the ccu the top connector controls the horn the wipers double locking and single locking check that the connections are good as the get a bit loose,if you...
  18. T

    Fuel Door keeps opening

    Hi the quick fix is go to your landy dealer and buy a new clip,make sure the flap is closing correctly on to plastic bit as they do bend,tiga
  19. T

    ES-X Gearbox changing probs?

    Hi there is a manual reset for the jatco box but that has never had that much effect to be honest,the recall only affected certain gearbox build nos and was a change of ecu and speed pick up sensor in gearbox,i have had good results fitting a new gearbox ecu,but your problem i have not had...
  20. T

    top speed

    Hi my disco done 95 mph easy back from gatwick on return from holiday down the m25/m3 i reckon it will do about 110 mph but would not like to wind the old transmisson up that much,bit noisy though,tiga
Back
Top