Search results

No protection at all on a D2 chassis from new except a crappy thin layer of black paint. I would certainly buy a galvanised one if they were made, I did ring richard chassis and marshland and both said no current plans to do it as the demand is not there yet and currently they dont have the...

Im confused, if ACE has been removed, how is the pump still there ? it will "overheat" as its normally cooled / lubed by the ACE fluid. it should have been replaced with an idler pulley and shorter V belt. Vehicles with air suspension have different NON-ACE bars than those with...

Just done that on mine, its just to costly to fix when it gets "old". Don't miss it all tbh either, its less than £380 to replace it with standard roll bars, more like £260 ish.... Land Rover sell Springs for 7 seaters, so if you want to "bin" the air, do it with factory parts and your...

check these guys out for proper points, more "local" to you ;) http://www.4x4intelligence.com.au/4x4i%20products%203Mar2010.pdf

Has it ever worked ? Have you connected any diagnostic equipment recently ? Have you been "into" the dash, its not unheard of that people "block / tape" over the ABS light because of 3 amigo's....

Have to agree, the ride is far better on air.

As posted Nanocom is currently the only tool that will program "used" keys, Testbook, Hawkeye, Autologic etc will all only do new keys with full barcode.

think its quite well priced for what it is tbh.

New nut ?? :confused:

I would not advise driving it tbh, the torsional damper is there for a reason due to the natural imbalance of a 5cyl engine. As far as the job goes, this should help www.discovery2.co.uk / Crankshaft pulley* / TV damper replacement

the ford in that video at that depth will pose no issues for your TD5 "as is", aslong as you dont enter it like an idiot and once your in create a bow wave and keep the pace smooth and you'll be fine......Just as the jeep did in the vid. if you want to stop water going into the fan, of which...

Is this noise def "in" the car, or outside the car. if its inside, then it could be the interior sensor fan is full of dust and it vibrates as it goes out of balance. To check this have a look with a torch through the little grille by the headlight adjuster switch. If its "outside" the...

Yep...........Why ?????????????????

standard ARB's are a straight swap, except you will need new ARB bushes as they are a smaller diameter. You will also need the pump removed, idler pulley fitting, new AUX belt and finally ECU told theres now no ACE.

Bomber lane, nice and simple with some stunning views, fine on your own, but........I def would NOT do Happy Valley on your own tbh.

You are correct, Hence the word "abuse" was in inverted comma's........ The point is, that "type" of post is simply frowned upon "elsewhere"......what happens on here is down to the mods to allow etc.........but if im honest judging by some of the signatures on here anything goes. In...

I fully understand your frustration etc with the whole situation, but you also have to accept the fact that a big percentange of forums / message boards simply dont allow the type of "abuse" that is not censored here at all....

Have you checked the wheel bearings for "play".....also when fitting the sensors, make sure they are FULLY seated into the hub, sometimes the "O" ring stops it being fully seated and then when you tighten the bolt down it just bends the bracket instead of fully seating the sensor.

38 MM spacer here 38mm (1 1/2) Towball Spacer from Tamar Trailer Towbar Centre

Fairenough, but I did say Autologic, not Testbook. ;)