Search results

Got it of car charging now

Only done short journey in car no time to charge properly sorry was finishing last post

Thanks data the earth for the dash is drivers side footwell I think and will fully charge battery have onl

Just tried it again dash came on for while then out but did notice radio code so had to put that in again could it be low battery even tho starting ok I will check all the earths tomorrow

Got intermittent dash lights now keep turning off also noticed check engine light coming on on start up after ignition on and off it goes out and up the old girl fires any suggestions as to cause much appreciated

Thanks blooody strip out everything again

Back to no heater right side not fixed then but now have book symbol and right blend motor open circuit fault on nanocom any suggestions or same as above strip down motor

That’s the plan data

Is the the older model data p28

Took her out for a drive today 1st time in 3years after taking her off the rd at start of lockdown and new I would be bored so started repairing and replacing 20 years of worn and rusted parts for new so all good now I hope for another 20 years

That’s all the work done now for me one day I will list what’s been done over the past 3 years on and off and the car been off the rd all that time but took her out for a run today all was good now all I got to do over the nxt 3 years is fit out a 47ft narrowboat

Thanks everyone for advice had a chance to look at the old girl today and the fix was quite simple put a screwdriver through the front vent moved the plastic bit inside a touch and its now blowing hot when I pick the screen & middle button and warm on screen when screen & rear button pushed so...

God dam it that would be to easy thanks again

Thanks data for the pic also the flap could be jammed yer I’ve not had a chance to look yet been on nights

Clear what faults there ain’t any wish there was would give a clue

Will try to look through vent see I’ve the plan is caught or broken thanks

Been like that all day here data hissing down

That’s what I was thinking just still wondering why left is hot but right stays cold as posted before blend motors are all new

Done that went from low to high a couple of times they changed from 100 to 0 and back up again a couple of times no problems

Will do thanks just drying off and a warm up then go and check