Search results

I’ve got the professional equipment for the job.

Thought I’d sand down a couple of spots to give the rear a lick of paint and uncovered a rust collection. Bugger.

Evening all! I’ve seen a few discussion about DIY headlining on the 90s but no huge detail (unless my search is just poor?). I would like to fit some headlining, and probably carry this down the back walls in the rear of the 90. I don’t want to use wood, as I assume it’s a ballache, so maybe...

I bought some glow in the dark fluid stuff a while back which you add to your oil, and then spot potential leaks using a black-light UV torch. Helped me find a couple of leaks, but only after I’d jet washed the hell out of what was there already. As @Dippypud said, the oil comes from one place...

Finally got enough bits together to re-fit the rear wheel carrier. Forgot how heavy the wheels are when I had to lift it back on though 😂

Painted up the light housings because I couldn’t bear to put them back in like that. Will order some new plastic ones as I’ve had to punch a big hole through them for the wiring relay. Replaced 3x leak off pipes which were also very much past their best. Finally installed the aforementioned...

If it’s anything like the stuff coming out of our pigeons, that’ll have taken a while. It’s like tarmac.

Have one of these coming mid-week https://ebay.us/m/OUkYpf

I think the issue may be the power being pulled down the driver side H4 lead. Considering at this point patching into the one on the passenger side for the headlight.

Today I’m trying to work out the puzzle which is the lighting wiring on the 90. There were some very poor connections behind which have been removed, but as 24 hours has passed since I took them off (due to torrential rain) I need to redraw the wiring so I can get it back together. If anyone...

This is an example from ebay @jon.evesham https://ebay.us/m/rQwlhf

My seat was much further towards the rear door and I fitted the corner bracket which comes with the mounting points. My body bolts are fitted with similar plates to yours. Does yours have the seatbelt connector pre-attached to the seat? I had to fit a floor mounted one which was simple enough...

Up in West Yorkshire but thanks for the offer @Phill

Noticed a new rattle and took the door card off to find the door is split near the lock. Thinking of a small plate with a few rivets for now as I can’t weld. Thoughts?

Taken it out for a drive this morning. Cooling nicely, no new noises. Only issue is a slightly higher idle than before. Pretty sure that’s just a screw adjustment. I’ll take a look when I’m wearing my scruffs again.

Need to do something about this green wire which is holding on for dear life

PROGRESS UPDATE:

Whilst I’m waiting for the charger to do its job this morning, I was matching up my fuel pipe routing compared to the video. I’ve drawn up a diagram which shows the flow. My fuel is starting into the lift pump rather than into the filter which doesn’t match, and I haven’t (yet) worked out how...

Yep. Pumping nicely.

Lift pump has been changed but now I’ve no crank. Off to borrow a battery charger 🤞🏻