Search results

Brilliant! Never occurred to me to use the trailer wiring. I've got the socket on the back but don't know if I've got a reverse feed there or is it somewhere else on all 38's regardless?. I did redo the socket 3 yrs ago as it was a rusty mess and it works fine towing a trailer but I didn't know...

First paragraph Nev...slight improvement that wasn't worth the cost imo.

The heater problem is bringing up the book symbol at a minimum. Windows are probably the switch pack switches.

6x3w =18w.

Can't see much when reversing in the dark, replacement led bulbs from halfords a bit better but still poor. I've spotted a durite(usually good quality stuff)reverse lamp that will fit quite neatly under the rear bumper for around £30. 6" wide, 1" high, 1"deep. Screenshot of the spec below. Bit...

For what it's worth...I've fitted rear abs sensors to the front on my 2001. Two front aftermarket sensors failed within 12 months so I got a pair of rear secondhand wabco ones off a breaker and the differance is in the cable length (bit shorter)but they still reach. Rears, as we all know, tend...

180ml in 10secs. Minimum.

Yes. Weirdly she ran well as long as the tank was 1/2 full or more. When I saw the gunk I thought maybe the pump was OK but a test showed it to be dead.

I feel bad now bitchin about the struggle I've had removing the tank to fit the new pump that's been on the shelf since just before Xmas. So I won't....

Are you running on chip oil/bio? Have you checked the lift pump is working?

Dunno...but I've got lots of 6mm tubing and a valve with a 6mm pushfit on it, well...4 valves actually. The good old eas emergency inflate kit. Is non of that any good for kermie ?

Got that stuff at mine if you need to borrow.

12 nuts, standard m8 nuts if you lose any.

It's easier with the manifold off for sure. The long one is a fiddle but if you reach round over? the fip with your right hand guiding the pipe with your left it's doable. Had to do that twice on mine.

It is 3.2mm inside diameter. The same tubeing is used from the inlet manifold to the map sensor(on the fuel filter housing) that one rots too. Its a bit of a bugger to do with the inlet manifold on, I take it off but in this weather and with your limited knowledge? Some of the manifold nuts are...

S Super rare and worth ££££££ ?

Sorry, only just seen the reply. Doors, bulkhead and seatbox disconnected and me and a mate removed the 110 van body. Wheels were off so it was lift-shunt-lift shunt etc until it reached the balance point at the rear of the chassis and was then tipped up on its end and shuffled out the way. The...

Ooppss..

I did a search and wammers post came up. I've got 4 wheel tc I think, 2001 dhse so it's no good for me.

Still giving Stirling service 3 yrs later, Ta mate!