Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. B

    3.5 efi wont start after running rough

    checked timing so thats bang on. Any other suggestions? Coughs after turning over for ages but not even close to starting?????
  2. B

    3.5 efi wont start after running rough

    As i say will check ignition timming tomorrow let any fuel evaporate and will let you know my findings. 3.5 efi mine did same drove ok on throttle but felt way down on power was after a few steep hill climbs and through a few fields. I changed from carbs to efi for reliability its fustrating...
  3. B

    3.5 efi wont start after running rough

    Will do thanks again will let you know how i get on
  4. B

    3.5 efi wont start after running rough

    Thanks Mr Noisy will get myself out after work reset ignition timing and take spark plugs out and let it dry itself out then re try tomorrow night. Dizzy does not seem to have moved though? But will give it a go as how you describe is exact same as my situation!
  5. B

    Fuel pressure regulator - vacuum hose.

    the back of the inlet plenum cheers
  6. B

    3.5 efi wont start after running rough

    Hi I have a 3.5 efi flapper from a range rover now in my 90. It was running great went a run in it for about 30 miles (had already been using it for a week or so 20 miles a day) then it started missing and cutting out. I cleaned all plugs and checked for spark (good spark). Plugs get soaked...
  7. B

    3.5 efi idle adjust

    cheers guys. I am getting a tapping noise from cylinder 2 and 4 which stops if i take ht lead off? there is no overheating and but cant figure out what it could be. Its like exhaust leak type noise any ideas? If i swap ht leads about on these cylinder noise goes but cylinder 2 exhaust runs...
  8. B

    3.5 efi idle adjust

    I was wondering if it is possible to adjust the idle on a 1988 3.5 EFI engine (from range rover classic) as its in a 90 there is no rev counter so i can only tell its high by listening. Cheers for any help
  9. B

    V8 overheating

    Has new radiator?
  10. B

    V8 overheating

    Ok cheers for help
  11. B

    V8 overheating

    Top hose is hot but doesnt feel pressured. Will pump from other engine fit just to make sure before I buy a new pump? Cheers.
  12. B

    V8 overheating

    Also with lid off the expansion tank water/coolant comes out the over flow
  13. B

    V8 overheating

    I have converted my 90 V8 from carb engine to a range rover lucas efi 3.5 engine runs sweet except overheats. Radiator gets warm after switching off - but blows cold air through matrix. With pipe off matrix there is very little water coming through - is this likely to be pump or could it be...
  14. B

    P38 Irregular Steering Wheel Vibration/Shudder

    How did you fix the seized viscous coupling? I experience a slight judder between 15 and 25 MPH only through steering wheel and only have wear on the inside of drivers front tyre. I also get a strange noise when i lift off above about 40 MPH which last a second or 2? Cheers
  15. B

    P38 Tow bar wiring

    Big thanks to everyone for input have wirred it up but yet to test it.
  16. B

    Slightly concerning rumble...

    I get similar noise but when lifting off at any speed above 40mph the sound lasts for a couple seconds max then goes away, i also get a judder between 15 and 20mph which felt like ujs but mine are all new as is front prop, on speaking to my friend he recons tracking is out and steering dampner...
  17. B

    P38 Tow bar wiring

    I have fitted a tow bar to my 1997 4.6HSE only problem is i cant find wiring diagram to connect wires from tow bar electric socket to the spare loom behind drivers side rear lights. Can anyone tell me which port on connector goes to which colour wire on the car? Many Thanks Brian
  18. B

    Big problem

    Sounds like oil pump check your oil pressure
  19. B

    Window problem

    Got this job to do at the weekend on drivers side as metal has cracked and window stops short of being all the way up. Any tips??
  20. B

    Has anyone replace bottom end bearings?

    Hi Gav that would be brilliant will pm you. Having to take a bit of a risk with crank being straight as it only happened 20 yards from house so no damage should have happened fingers crossed, Mainly can't and don't have money to spend just now after our so called trusty VW Golf (that she...
Back
Top