Search results

There are 2 of them and they are above the gearbox and from memory in line with near the front of the front doors! If you crawl under you can see the one on the right easiest it's about 15mm diameter and is ussually covered in muck! Use a bit of welding wire or something similar with a small...

Ah...lamriska has answered my question!!

I would also check that your pivot bearings are ok as any play will cause the seal to move away from the ball....and change from oil to the swivel grease that you can get from Land Rover dealers....not sure if you can get it elsewhere??!

several bearings in each diff and output bearings on transfer box so these could be at fault but best to work back from the wheels to gearbox....just a thought have you checked the front CV joints do you think it is coming from the front or back of the vehicle???

Yes but best to chock wheels and have handbrake off and in neutral so that you can feel for play in UJ's....it should be obvious if it is that!!

Might be worth checking propshaft UJ's or wheel bearings?!?!!

Hi, I need to replace both front and rear as there is a fairly big wear step on all of them! Also getting quite a lot of squealing thought it might be worth uprating the discs either just with different pads or usinf a combination of pads and discs but have no experience of the ones that are...

I need to get new discs and Pads for my motor, has anyone any views on this? i.e. Get standard discs and pads, standard discs Mintex pads, grooved/dimpled/cross drilled discs, greenstuff pads etc etc. I use the car mainly on-road but also off road every now and then! Also any good suppliers?

When BMW owned Land Rover they put a proto X5 on the suspension test rig. The suspension broke on the warm up cycle i.e. before the test proper actually started! The L322 passed the test! Enough said.

Also found this: Land Rover Owner :: View topic - V8 - which is which? Good luck!!

Just done a search on the web and found this Tuning the Rover V8 Hope this works!

Guess some might but not the cheap ones I buy!!!!

I've topped them up before just cover the plates then charge with the covers loose, then push home completely before you use it.

I would....water end electricery don't mix!!! Just make sure you have your radio code before you do it!!!!!!!!!!!!!!

yeah but we didn't do them....they were done by Land Rover Gear!

No Sean! Not like keyrings:rolleyes: Mainly roof racks!

Riv-Nuts and Nut-Serts are trade names for the same thing!

Heated Seat Repair Operations

Are they the Safari 5000 lamps? i.e genuine accessory part number STC8480? On these the stone guards do unclip! I will find out about fogging issues and get back to you!

Just found this on another site! Does this make sense? Normal Operation which Might Seem Faulty: The air suspension is controlled by an ECU under the drivers seat, which operates a solenoid valve block in the engine compartment. The ECU has a fairly low IQ, and wastes a lot of air by raising...