Search results

Easy home job .... Part is a sealed unit which has a push connection .. Do a quick search on clutch master cylinder ... Lots on here about it Chris

Mine has never failed mot because of egr bypass Chris

I went for an aluminium one ... Chris

As I said..... Not a problem in the end.... As I didn't have factory fogs, I just used the wires that were already hiding behind the bumper... Just put the switch in the dash and 2 relays in the fuse box Chris

as it says above Wanted, leather gear knob for freelander 1 facelift..... Manual Cheers Chris

I've got geolanders on mine As previously stated, in my opinion they are a little better on the road than the at2 and probably just as good off road ( had grabbers on a previous freelander) I got a great deal for a set of 4 from blackcircles which made the decision easy .... Over 40 quid per...

Freelandie71 No.... They are the ones in pods that sit on the unpainted part of the bumper........ Just that this is the fog light version of the kit rather than spots Chris

Sorted....... Managed to get hold if the original connectors........ Soldered the new connectors to those and hey presto all works... Lesson there is .... Anyone buying the fog light version of these pods ..... If you don't have factory fogs then the loom is already in there and you don't need...

Freelandie71 Yes that is correct for the spot light kit where you end up with the switch low down on the right hand side next to the park sensor switch Mine are the fog version where the switch is in the centre of the dash where the hazard switch is . As I said earlier I can see the wires and...

Thanks teddywood Really annoying me to fail at the end.... My car hasn't got factory fogs so considered using the plugs that are already there behind bumper but can't get hold of them throught the holes I've cut for the fog lights Chris

just fitted my facelift fog lights and pods and everything has gone quite well until I've come to the final connection.... The Land Rover picture instructions seem to suggest removing fuse board from under dash to gain access to plug number c2624 I've undone the 2 bolts at the bottom of...

Started the fitting of my light pods...... Those Land Rover instructions aren't the best but just about Sussed it..... Just got to do. The fiddling with the multi plug on back of fuse board and then try to thread the wires down to meet the lights It got a bit cold so I gave up for today ...

Thanks for the replies .... Was thinking of a different colour but seeing as my car is black I think the original is probably best ....... Those who have painted these , dit you lacquer them.... ? Chris

Cheers zdomz

anyone know the paint code for the door handle , console silvery trim bits . Cheers Chris

Here's hoping !!

Merry Christmas to all Just been on radio that we may have a few inches of snow here in the northwest tomorrow ....... Let's hope so ..... Playtime !!! Chris

Yes... Those are the ones ....

looking to get some of the above.... Has anyone fitted these...... Does the bumper have to come off to fit them Cheers Chris

Fitted some H7 led headlight bulbs ........ Will be putting old ones back in tomorrow.... The led ones are crap !!!