Search results

Thanks but no not that bit, the threaded piece at the very bottom right of your picture. I discovered you can push the rubber over this part to remove it so as a temp fix I have replaced it with a 6mm bolt and some nuts as spacers, I guess I will need to buy a second hand sensor and take the...

So set to replacing the lower suspension arm after MOT failure of the ball joint, upon undoing the bolt that hold the ride height sensor arm to the suspension arm the small bolt sheared. Can the plastic arm be removed from the sensor easily, it is plastic and look brittle? What options do I...

Evening All, So MOT day:eek: failed of course.................. Hand Brake efficiency below requirement, recently did the rear discs, pads, hand brake shoes and callipers. I tried in vain to adjust the hand brake before the test, so as per service manual adjust right up and back off 8 clicks...

I had a similar issue when my adaptor stripped and would no longer rotate the locking nut. You can get locking wheel nut removal sockets, you select one a bit bigger than the nut. When you put them on rotating the socket causes it to cut into the nut and eventually it will rotate it off. You...

I did mine about this time last year, not such a bad job, I followed the overhaul instructions posted here but my pump leaked. I then bought a recon pump off the bay and haven't looked back, cost me less than 300 quid from memory. Whilst you have the manifold off worth cleaning the ERG and maybe...

Thanks Freelance To be fair the pads weren't that bad nor the discs, just thought as I was stripping it all down would replace everything.

Thanks Freelance, Was looking at that whilst pondering today, they have rubber gaters on them, do they come off easily and is there likely to be crap behind them?

Thanks Guys, Vin is 6A2 so should be vented. I'll get them swapped

Hello all, This is probably a stupid question but..... My hand brake shoes fell to pieces making a nasty rubbing noise, so set about changing rear discs pads and hand brake shoes. New Brembo disc supplied by Euro are 12mm thick solids, the ones I took off are 22mm externally vented. This just...

We had a similar issue with out 2005 L322, bought a leather stitch on one off eBay. The missus stitched it on so can't vouch for the ease of firing but she said it was easy and they have the stitch holes pre punched. Impressed when fitted and other have agreed. Much safer than an airbag splat:D

So went on my favorite auction site and for the princely sum of £7.31 bought an active GPS antenna with Fakra-C cable. Popped the SatNav unit out of the rear equipment area and connected it in place of the roof mounted one. I instantly got reception from 6 satellites and working GPS with new...

Thanks BackinBlack, I watched that earlier so at least I know I can get it off, looking at the roof it isn't really tight on the back and there is water around it but I was out in the rain earlier. I read on another forum it is possible to replace it with a cheap GPS module for less than a...

I just took the Sat Nav DVD drive, which I believe is also the computer, out and checked the connectors and they are all clean and dry so I think it has to be the antena. I see a new one can be had for £125 so I'm going to look to see if I can't find a cheaper alternative. I'll post back what I...

I had water ingress which wiped out the phone BT module, I took everything out, dried it out, replaced the BT module and fitted a plastic bag over everything, luckily it hasn't got wet again since. Where does the GPS antenna plug in so I can check the connections?

Sorry half my post disappeared, does the above indicate the gps receiver in the shark fin has died or is there something else I should check. If it is the reciever is there an option to swap it for a generic one or do I have to get a RR original? Thanks

Hello all, My 05 L322 Diesel has a sat nav problem in that it no longer seems to know where I am. Yesterday whilst out it put my position about 50 miles off and at one point it thought we were in the sea. I have been in the hidden system menu, self test results in 80 - 3A, under GPS it states...

M57 Wikipedia site has following info, can't vouch if it is correct: M57D30 130 kW (177 PS) and 390 N⋅m (288 lb⋅ft) in the Range Rover L322[5] 135 kW (184 PS) and 390 N⋅m (288 lb⋅ft) in the E39 as 530d[5] in the E46 as 330d/330xd[5] 135 kW (184 PS) and 410 N⋅m (302 lb⋅ft) in the E38 as...

Can't help you on BMW vehicles but the engine should be a BMW M57 in your L322 if that helps.

Feel you pain had similar troubles after changing the fuel pump after mouse damage. Diagnostics on mine 2006 didn't yield anything do you have access to a machine to see if any errors are present? When you changed the fuel pump did you notice if the air in let was really dirty? If so try to...

They should be in the boot on the drivers side, they are under the cover that pops out at the top. Opposite side to where all AV and Sat Nav kit sits. I too have a 2006 that seems to be a 2005/2006 hybrid.