Search results

Hi, yes i already changed the FPR o rings last weekend. I guess i would have to put it up on the lift to be able to see if the highP pump is leaking will have to wait till the weekend.

been raining a lot today but took off the FPS cable and tried to start but same , does that mean the loom is ok ? Also Does anyone know what pedal demand is on the icarsoft ? I'm going to try to do an injector leak test at the weekend when i have some time . what are best practises when using...

does the high pressure data look ok in this video when cranking?

still the same , cranks over and over but won't start without easy start except for in the morning when it's been sitting overnight then it sometimes starts after about 10-15 seconds. But not always

Thanks , I don't suppose the upgraded wiring loom would work with the original sensor?

Thanks for the replys guys, So I went into town about 10 miles and back and all went well till just before home on a hill i wanted to test the acceleration put the foot down and got an almost immediate engine light and was in limp mode i think . I checked the code for the error and it's P1190...

Thanks guys , so I took off all needed, accessed the sensor and cleaned off the connectors of all the yellowy green stuff with iso-alco and some q tips but unfortunately it did not seem to have any effect on the starting issue . It cranks and almost starts now and again but never succeeds. Good...

Hi all , So i have been fixing up my 2003 td4 that has been off the road for about 2 years and I have run into a problem that I need some advice about . I have trouble starting and after changing the fuel filter , glow plugs and changing the o-rings on the FPR the problem persists . When it...

Ordered 3 metres of silicon pipe off amazon , thanks for the tip

Ah i see , well I am soon going to change out the brake lines and so will have porobably an offcut suitable for this job . Thanks for clearing that up for me , much appreciated .

Thanks , it looks like this one has been bodged at some stage , one end of the vacuum accumulator has a screw in it .

doing a service on my 2003 td4 and i noticed that the pipe from the egr valve was just hanging on it's own and also a long pipe at the crankcase filter housing. Anyone know where it goes?

I'm an idiot. I've not driven it for a year and forgot about what way the lights were configured . Turns out the bulb was gone in the driver side light and the passenger side was very corroded and a connecter snapped off during cleaning so ordering a new brake/ indicator connector set and that...

ok so my brake lights are the ones up with the reverse lights , the bottom 2 red ones on the bumper are just running lights that come on with the headlights. The indicators on the back bumper are also working fine Plus the bulbs are working because i took each one out and tested them in a...

So I had a look and I have to admit it's all a bit over my head In the rave manual under 2003my - description and operation - brake and reverse lamps - brake lamps it says: Brake Lamps .The brake pedal switch (C0075) is provided an ignition feed from fuse 2 of the passenger compartment...

Thank you for your reply I will have a look

In addition there are no DTC codes to read and maybe the blue wire is not supposed to go anywhere , I cant see an obvious place for it.

Hi All, I have posted a couple of times before , still have the same td4 and have been doing a few bits to it . Yesterday was replacing pads, discs and calipers on both front wheels all went well except that when i was backing out my buddy noticed both my brake lights aren't working , the top...

sorry , i was out working all day , Nodge nailed it . i'm a bit slow anyway ... thanks for all your replies , i was going to purchase parts i didn't need . will post back when fusebox installed

Just got it back from the shop, tech says it is a faulty fuse board , wired up a temporary solution till i can source a new fuseboard. Is this safe?