Search results

Hi do your gear selection lights sit in the correct position have you tried manual selection is it the same gearbox filter should be done about every 24k,do you ever get the m&s lights flashing or F3 flashing in instument pack,there is a speed sensor in the gearbox which can play up easy to get...

Hi you will have to get it plugged in to find the cause,but 1 question i have is is your battery ok not gone flat or below 10volts as this can cause problems and induce a fault if you think your battery is ok,then you could try a hard reset,this is disconect the battery leave at least 30 mins...

Hi its quite easy really just pull gently on the top corners of headlight they are only held in by 3 plastic ball and clips best to do it when they are warm as they are brittle when cold hope this helps,tiga

I have spent loads of time on abs on disco 2, 1 common fault is the earth above the glove box where the slabs is located its a single black wire on its own and this is a main earth point for slabs not allways shown on wiring diagrams and often overlooked,the other thing is that a overlay harness...

Hi all the models have the same similar problems except the ones without terrain response and air suspension but who wants to go that cheap,and no dont even try and think about fitting things after as the wiring looms differ and its hell of a job to fit a complete new harness,most of the faults...

Hi are you sure its the compressor as if its gone down overnight sounds like a leak,and if you have a faulty height sensor it wont lift either is the fuse and the relay ok i would check these first as compressors are expensive,tiga

Hi all td5s have centre seat belt but to save yourself money go to halfords or such like and fit a 3 point belt yourself i did as i have 3 children it works great,tiga

Hi boys the td5 does not have the gutter seam only 300 and 200 tdi if it leaks in at the back its allways sunroof especially were the motor sits in he half moon shape seal this with silicone check the drain off tubes are attached to sun roof correctly and the rear alpine windows leak,easy fix...

You could wire it to cigar lighter thats position 1 or the same feed as radio thats position 1 or if you go to fuse box under steering column you will find a 3 way slot that has a live on position 2 this might have a single green wire in a brown connector if dvd or front driving lamps are fitted...

Hi have you checked all vacuum pipes as this will make it surge also the stepper motor on the left hand rear of phlenum chamber could be sooted up as this also controls fuel at cold start and warm running try these 1st,tiga

The air suspension pumps have had problems with failing at an early age due to what i would call a manufacturing fault,never changed an auto box yet our dealership has had no problems.But have done 2 clutches on manuals both i must say to driver error and abuse.God forbid LR going back to BMW...

It does not sound like the system has been bleed properly,easy way is take off pipe at thermostat top,this is a small bleed back pipe which goes to a 3 way connector going to expansion tank,take off pipe and get your laughing gear around expansion tank and blow hard while holding finger on...

well street boy i have never seen the liners move on any v8 and i have played with a few i stand by the fact the bores go pourous on the beast although have not done many lately,as many people cant afford LR prices,never seen trouble on the smaller v8s thou,tiga

i would give em hell as well !

It should not change anything apart from hot start fault so i would go back and check you have it wired up right as something is wrong,tiga

hi you could go and get the revs turned down,but thats not sorting the problem did it rev high before the mod? as the mod should only change how the vehicle starts,tiga

It sounds like you may have done something wrong as it should tickover the same as before check out all your connections again to make sure you have not put a wire on wrongcheers tiga

hi if the engine cranks and its got a spark i dought its getting immobilised as thats the 2 circuits that would go down,a main fault on v8s is the immobilisor not giving the full 12v to the ignition coil easy way to test this if no multimeter is get a piece of wire and run it straight from the...

hi had a look at the welder it does state in add single phase 230v,this is a workshop welder normally plugged into heavier wiring and is normally seen to have a blue and white 3 pin plug on but as you have to plug it in the mains any way stick a normal plug on it,tiga

Yes i ave a good idea sounds like the rear diff front mount only about 16 pound to buy but more difficult to fit on your back main dealer will charge about 15 mins to fit hope this helps tiga.