Datatek
Well-Known Member
- Posts
- 45,757
- Location
- Near Poitiers SW France
Yep, I always raise the front to refill the system.
P38A Overheating
- Thread starter Monkeynuts321
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
RangeRoller dt
Well-Sprung Member
- Posts
- 14,604
- Location
- Trapped inside my head @ LZ asylum
Yip, was you showed me that one
I didn't like tension clips until, I got the tool to release them, the cable type for difficult to access ones.
- Posts
- 36,220
- Location
- North Shropshire
The problem i have is that they bend slightly at the far end of the screw unless you have exactly the right size.. then you have a small section with less/no compression
Monkeynuts321
Member
- Posts
- 10
- Location
- Harlow
I would like to thank everyone for there help with my overheating problems i bleed the cooling system ran the engine for nearly an hour no problems then the new clutch i put in on the viscous fan started to kick in which it didn't do before I could have dried my hair with the air that came off it but I haven't got any
thank you very much everyone.
Datatek
Well-Known Member
- Posts
- 45,757
- Location
- Near Poitiers SW France
Well done and thanks for reporting back.I would like to thank everyone for there help with my overheating problems i bleed the cooling system ran the engine for nearly an hour no problems then the new clutch i put in on the viscous fan started to kick in which it didn't do before I could have dried my hair with the air that came off it but I haven't got any
