Recent content by Zarakoff

Hi all , What size clamp do I need for the 1.8 freelander 2004 the part where the back box joins the rest of the exhaust mines popped out and the clamp bolts sheared off I’m not to sure how the clamps are measured to get the correct size It looks just over 2 inch so was hoping the 57 mm will...

Well in the end it was easy just in case anyone does have any problems Hold 2 and 6 (it gives you your serial number ) saved taking the unit out Then for a grand some of 99p (from eBay ) You get your code within a few minutes and get presto it works fine ... mines only a off roader field 4x4...

I’ve just checked my serial number by holding 2 and 6 .... Is the code the last 5 numbers ? Googling it points to this but how many goes do you get before it’s locked ??

no hand book I’m sure land rover do this as a free service but wasn’t sure who to contact

So battery was flat charged up radio code blinking I know you press the numbers then seek to confirm code . My problem is where do I get my code from is this a free service with the serial number of my unit or am I going have to pay to get the code many thanks

Thanks will any reader do the job ? They seem cheap on eBay

So had the freelander a couple of months and the check engine light comes on 1 day and off the next . Drives well no loss of power . What will the cause likely to be ? Is it always a faulty o2 censor ? I can’t get it to a garage as no insurance or m o t it’s just used as a off roader Thanks

oppps I’ve put it in now . S*** I asked the garage do the head casket they said try this . If it dies il be in touch

it’s just gone water in the oil only done 69k but I know it common. We only use it as a off roader in our field the garage said try steal seal it does a permanent job for only £30 and money back guarantee. So I’ve give this ago first as the car is Sorn so would be a problem taking it to the...

Thanks il give it ago today .ive just sealed the head casket so the oil needs to be changed

Thanks for that found them . It’s on the front I was looking at the opposite end lol never know drain plugs at the front . Now to get the cover bolts for the front out

Thanks for that I take it that’s from the back of the engine towards the inside of car not the front ?

Hi so removed so screws on the under tray to change oil on 2004 freelander 1.8 petrol got the far side off drops down the two under the front bumper are stuck so soaked them in wd 40 the problem is where the hell is the oil sump plug there seem to be a few nuts under there but for the life of me...

Hi could anyone comfirm the bleed point on freelander 2004 1.8 petrol engine To drain the radiator water I know to remove the pipe near the dipstick and the screw on the pipe going through the bulk head . It’s just the one near the engine is it the long rubber one with the cap on or some...