Recent content by Yarmite

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Yarmite

    Wheel stud pulled out

    Hello all, one of the front wheel studs has pulled out and in the process has ruined the thread. What’s the best remedy for this now? Is there any recommendations on recapping the thread and to what size and then what size studs do I go for? It’s the screw type on a 1963 Series 2A...
  2. Yarmite

    15j 2.5na vacuum pump

    This thread fought my eye as I have a 14j engine and also has the vacuum pump still attached, at least I’m assuming that’s what it is. What’s best to blank them off?
  3. Yarmite

    Fitting inertia seat belts to series 2a

    Yes, that’s for the posts. I have all the parts. Most are fitted using both the upper and lower brackets. However I still have the challenge to fill the retaining buckle. I’ll need to find a way to support under the seat box to the chassis.
  4. Yarmite

    Help to identify the overdrive unit

    Thanks for the reassurance. The oil leak is only minor but there are a few places including engine, gearbox and transfer box that have a small leak. So lots to keep me busy. I’ve only owned it for a few weeks so trying to sort the issues out bit by bit. I’ll be doing full fluid change anyway as...
  5. Yarmite

    Help to identify the overdrive unit

    Ah I wasn’t aware it’s supposed to have a dip stick for the overdrive. I’ve only had it just over a week so still learning what’s what with it. I’ll have to find some strip down images. Thanks
  6. Yarmite

    Fitting inertia seat belts to series 2a

    Those look dry good for the price but I’m just not sure where is best to bolt them down to they stay attached should the wrist happen. Thanks R
  7. Yarmite

    Fitting inertia seat belts to series 2a

    Hi, yea please share the pics. I’d like to see how and where they are mounted. I’m banned from driving the LR until I’ve fitted some safety Cheers
  8. Yarmite

    Fitting inertia seat belts to series 2a

    hello all, Does anyone of some guidance on fitting s at belts. Currently there are non and I dues feel right when driving as you are exposed enough as it is. The side pillars are as below. Cheers
  9. Yarmite

    Help to identify the overdrive unit

    Hello all, There’s a leak on the top cover so I need to replace the gasket. I assume it’s a fairy but I’m not certain as I think there are a couple of options. Cheers
  10. Yarmite

    Hi to all, new to LZ

    Good evening, I’m the new proud owner of a 1963 series 2A. It’s a diesel but looks like at some point in the distant past a 2.5 na 14j was installed, so not original. There’s an overdrive as a bonus but I’ll need practice the double declutch for dropping down into second as I’ve not mastered...
Back
Top