Recent content by WASEEM HUSSAIN

Hi am looking for someone in the Leicester/Leicestershire area that has a nanocom as I have purchased a land rover discovery 2 that has had its seats swapped from the manual to the power seats and requires the bcu enabled to allow power to the seats. I am happy to pay have seen some on feabay...

how would I be able to sort the bad comms out.

Hi so far tried The Relay, fuses f29 and f40 all three show no damage, swapped a working relay just in case rely was blowen, no change, have tested the compressor using the relay jumper method compressor runs, checked for leaks using soapy water on all pipes and air bags none found. connected...

This may sound like a silly question but how would I do that?

Nothing runs, have tried the pump on a different RRp38 and it runs up. but as soon as I try it inmine nothing just the eas fault beeps. all sides have now been rised using the emergency air valves and are holding there pressure fine. just dont want to drive it like it is unless it is urgent.

Hi sorry when the eas software is plugged in shows fl height incorrect same with all four side apart from that it is showing no other errors or codes. the vehicle has dropped to bump stops and have not drivin it. on the dash it is showing the high ride height symbol and the eas fault along with...

Hi have a issue with the air suspension on my 2000 range rover p38, the air suspension failed, I have replaced the air compressor pump, checked for leaks on the all pipes, checks air bags no leaks there, the eas fault warning is on and will not clear, have checked all fuses and relay, checked...

Many thanks for that, but I should have asked the correct question, the ride heghts for the EAS ECU are the one which I seem to be unable to find. again sorry for the mistake.

Hi was wondering if someone was able to tell me the correct air suspension ride heights as mine is a new system as I have changed it from coil springs back to eas. many thanks in advance.

which post #40 and what is if i my ask the swann vesta fix?

Hi everybody just an update, replaced maf unit, camshaft sensor, fuel pump, all 8 spark plugs and the ignition pack and now the thing refuses to start and now am lost. all parts are oem parts and not ebay knock off, the rangie is tryin to tick over but will not start. any help would be welcome.

yes the new mech is a jaguar landrover technician working at the solihull plant in birmingham even he was buffed by the rangies codes. will get on with the above advise and get back asap.

Good evening Just a update with my problem new maf sensor fitted , all faults cleared and after start up the rangie barely idles and when you press the acc it pops and squirting flame out of the exhaust. no new faults showing and now light blue smoke out the exhaust until it warms up, but the...

Sorry for this but is any diagrams of the locations of the above sensors or photos that would indicate the location of the engine components. yes the maf wiring was checked before fitting new one but I am starting to consider the new maf maybe faulty. also could you direct me to the location for...

Finally got a mechanic that believes what he states, had a diagnostic done and the following faults where found Stored DTC(S) P0102 MAFS Circuit Low Input Y A P0103 MAFS circuit high input Y A P0340 Camshaft sensorcircuit fault or signal timing different from crankshaft sensorsignal Y A...