Recent content by walter2004

Job done. just over an hour to do. Light still on in dash. May have to put up with it or testbook. Many thanks

Thanks for all advice. Forgot to ask, Is there a fuse I can remove to put out the light on dash and stop power to compressor or do I remove bulb and remove multiplug. Save me the cost and hassel of putting on Testbook. regards Walter

I need a air compressor and 2 air springs for rear. I have bought a spring kit to replace air suspension. I will have no problem fitting springs but can someone tell me how the air springs are removed. Many thanks walter

No. If I had I would have looked at it before posting. Hope that does not sound like cheek

A yellow light shaped like a car looking from above with two arrows coming out either side. When going round corners the light changes to red along with a beeping soung. Any ideas Regards Les

Not too bad for an auto

damper should not make a noise and no the pads being tight is not the problem. If it was ok before fitting the damper why not fit the old one back on and try?

There are so many bushes at the front end that you need a good damper to take away any shake. when you go over a bump at speed the rubber bushes will flex and without the damper the steering will shake violently until you slow down. I would first off check when someone is shaking steering...

First off find out which Cyl is giving miss by pulling off leads one at a time then swop plugs and lead over and if it is the same Cyl then you have got to think it will not be injector as it still misses on gas. if the compression is ok or close remove the rocker cover on that bank and check...

Remove the fuel filter and fuel should be at top. If half way down you may have a air leak in pipes from tank. Bad for corroding

All good advice but watch out if it has abs when bleeding brakes.

very rare to have a problem with non landrover exhausts. you should get co checked to see if it is rich before trying to find a fault. Any number of reasons for over fueling although the o2 sensor should pick this up and if it could not control it it would go open loop and the computer would...

When customer turns key to start engine, rear door opens from latch. If when using key fob and just unlock once so drivers door only opens it is ok. If you press fob twice for all doors to unlock this is when the fault occurs. Any ideas

Depends on what model of disco. If 2 or 300 then just remove the pulley then the high and low pressure pipes at the pump. Then remove the four bolts that hold the pump to the casing and remove the pump rearwards.

. When it starts to get sluggish stop right away.If it is NOT a TD5 then remove fuel filter. When unscrewing the filter, fuel should spill out before it is completely removed. if not, once removed look inside and the fuel should be at the top. If it is then no air leaks to the filter. If...