Recent content by ty8ight

Ok, so latest update - Took the car out and 3 amigos return, Grrr Plugged the Hawkeye in again and this is my fault code now. 4084 - HISTORICAL Sensor Right Hand Front (intermittent sensor output during driving, broken wire) If i clear the fault codes and rescan, it says no faults...(and no...

No, i had no SLS warning. And i'll admit that it wouldn't surprise me at all if the 3 amigos were to return.. The only faults though were related to the SLS and now i have no fault codes... Ah well, time will tell...just keep my fingers crossed.

Mmm, should be ok, it's only about a year old and it's a heavy duty Varta...i'll have a check on that tomorrow as it's still under warranty...Thanks..

UPDATE - Hooked the Hawkeye up again, went through the ABS programming menu, and sure enough it was set up for Airbags not coils!!! Changed back to coils and cleared the codes and all seems good (only drove a couple of miles though) I've had the car for a little over two years now though and...

Am i right in thinking that the height sensors are only fitted to vehicles with SLS?? The Exhaust and compressor faults obviously are connected to airbag suspension BUT I've got Coil springs.... If a coil sprung Disco has no rear height sensors then none of the fault codes i have are related to...

Ok, so i've checked out the SLABS ECU connector's, all seemed clean and dry. Sprayed some switch cleaner in there to make sure. Reconnected everything and cleared the fault codes. Took it for a drive and all was good for about 5 miles, then they all came back again.... So, anybody got any...

Thanks very much sierrafery....i'll be on that tomorrow then (weather permitting that is)...Will report back.

Without wanting to sound thick, errr where would i find that??

Evening all, Got the three Amigos come up on my Disco 2 (ABS, Traction Control and Hill descent warning lights). so out came the Hawkeye and it has thrown up these fault codes - 4130 - Rear left height sensor out of range (Short or broken wire) 4131 - Rear right height sensor out of range...