Recent content by toto25

hello to all, well I have a problem, and I can not identify the source. I have a typical hoarse noise (rowwaaaaaaaaa) at low speed a bit like something rubbing, I think it's a wheel bearing but 3 out of 4 are almost new, gimbals ok, the gears shift well. brake are ok no braking noise. Can you...

ok , merci beaucoup

hi , i have a prob , I bought a floflex silent block kit, I changed the lower right support, not without difficulty because the aluminum axle supplied with the kit is 35mm but the original is 32 mm long. The 35 and too long and does not fit. I reduce it and it's ok. Only the car vibrates at...

hello, after having dismantled the entire starter, cleaned with brake cleaners and sandpaper. The starter seems to run hot.:):D Thank you all for your help

hi this item ? Freelander 2.0 TD4 Diesel Denso Démarreur Solénoide Kit Réparation 228000-7801 | eBay thank you

no i have not make this test , engine cold all is ok

hi , Nodge68 The relay seems to be ok, I measured 100 ohms when hot. And also swapped two relays. But meaning effect. Engine still won't start warm. thank

ok , i have checked a relay : pin 2 and 1 : 0.138 ohms pin 3 and 5 : infiniti thank

thanks a lot for your help Nodge68 ; I will look tomorrow morning. an idea came to me: Could the inertia button be the problem? best regards

thank you for your help, the solenoid is not oxidized and does not click at all.

hi , my td4 starts very well when cold, and after driving then stopping the car in very hot weather (+30) the car does not start (starter does not turn). Do you have any idea of the problem? I also noticed that the fan in ecm spins when it refuses to start. This fan seems to be controlled by a...