Recent content by Tommy79

Will definatley find out as to the origin of these parts, it certainly cost me enough so I'd hope they're genuine parts. Thanks for the suggestions, hopefully will be running smooth again soon!!

Thanks Mike, bearings were replaced at the same time. It's starting to sound expensive to fix given all the possibilities of what's wrong, may have to end up selling for spares/repair.

The VCU was a new unit from a local garage. As to the vibration, it feels like it's mid propshaft where the VCU is.

Thanks, just seen a thread about the VCU test and will try it out this evening. Is it possible that it could be knackered even though the VCU is 2 years old and only covered about 8000 miles in that time?

I recently started to be getting a lot of vibration when turning corners at low speed (below 20mph) and today I got it when slowing down in a straight line. I had the VCU replaced about 2 years ago so I'm sure it can't be this at fault. Is there any other explanation as to why this is happening?

Just tried replacing the coolant expansion tank, got both pipes off then got stuck at the mounting screw. It just spun and wouldn't loosen, is there a specific way to remove the mounting screw?