Recent content by the murfster
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Thanks for the info,just checked the one I have goes upto 180nm. so result.
-
Thanks
I'll torque it tomorrow then keep an eye on it.
Thanks
-
That's great thanks for the reply,think my torque wrench goes upto 110nm.
Was thinking of upgrading to a bigger torque wrench maybe nows the time.
-
Had td5 90 vague steering for a while could not find the issue till today.
The drop arm was loose on the box even though the lock tab was in its proper position.
Got the half inch snap on basher gun on it that took it up two full threads,took all the play out of it now a far better drive (thank...
-
Had same problem on my wife's 110 for a few years,done everything all new calipers discs etc.
In at irb for some work wife mentioned it to Ian,he did a smoke test on it,an
d he found the servo had split either side of its mounting bracket showed me a video of smoke coming out in two places...
-
The kit irb has is designed for a defender,I've seen it in action very impressive.
-
A freind of mine fits & supplies complete kits,Ian at irb.
Never enquired though probally not cheap.
-
-
Happened mine a few years ago was adised swap aswitch near the master cylinder the name of it escapes me but it cured it.
-
Put a new pump in my td5 defender tank this afternoon.
Paid ian @ irb to cut the floor above the tank a few years ago & fit a removable cover.
Its the only way swapped in an hour & running again & a quiet pump for the first time in a couple of years & starts first time it was getting harder &...
-
-
Give ian at irb a ring,just put a replacement engine in my wifes td5,perfect job cant fault him
Hes nr sutton coldfield w mids
-
Fitted new discs & pads to my td5 90 rear axle all went well
-
Hi Remingto
Posh end of mile oak
-
You can remove complete and do the seals