Recent content by tgordine

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. T

    P38A P38 erratic idle speed

    Apologies, I completely forgot to mention that when I put the car in drive or reverse then it starts to idle fine. I only seem to be getting the idle problems when I'm in park or neutral.
  2. T

    P38A P38 erratic idle speed

    Unfortunately I find myself back on the forums again as I have been pulling my hair out once again with an issue that I can't seem to make sense of. A few months ago my 4.0L V8 98 P38 started idling erratically whereby it would start fine but within about a second the idle speed was around...
  3. T

    Advice when replacing head gasket on P38

    I have had a small oil leak on my 98 4.0 GEMS engine for a little while but had been unable to locate the source, I initially thought it was just simply the sump gasket as I could see the oil dripping from the sump. Unfortunately this proved to be incorrect as when I was replacing the drivers...
  4. T

    P38A Unable to start P38 Range Rover

    Well the Range Rovernow works again, as well as it did anyway. All it was in the end was me being stupid and not transferring over the metal clip on the batterycover. swapped it over to the new cover and I can now unlock the car (the rear doors anyway) then unlock the drivers door manually and...
  5. T

    P38A Unable to start P38 Range Rover

    Yeah unfortunately the one I got was some cheap thing and it didn't have the metal strip, I will swap it over tonight and see if I can at least get the LEDs working on the fob again. I have emailed my local LR dealer to see if I can get my EKA code and then hopefully from there I can get...
  6. T

    P38A Unable to start P38 Range Rover

    I don't recall seeing the metal strip on the new battery cover. Think I will have to try and remove it from the old one and see how I get on from there. I guess now that would explain why I don't get any lights on the fob when pressing any of the buttons as without it there wouldn't be a...
  7. T

    P38A Unable to start P38 Range Rover

    I didn't actually check the voltage on the car battery so I will do that tomorrow, I did check the fob batteries and both were reading at just over 3v so I believe they are ok. When pressing the buttons on the fob I get no lights whatsoever on the fob now, this did however work fine before I...
  8. T

    P38A Unable to start P38 Range Rover

    Hello all, I am new to owning a Range Rover and everything was working fine until a couple of days ago. I was driving along and got the "Alternator Fault" message appear on the dash, got it tested and it was pretty much dead. I got it reconditioned but either the garage disconnected the battery...
Back
Top