tank93's latest activity

Something like this you mean?

I have no idea why they didn't just pop out, very frustrating, I was cursing yesterday :mad:. Maybe its because it had this nut type fixing, this isnt my bag because I had to smash it off but its representative of the connection it had on my...

Should be fine with those springs, yes original fitment them. I wonder if someone used a glue of some sort and that's why they wouldn't come out? Follow datatechs 'how to' in the tech archive.

True, I still prefer the plastic ones with O rings as used in effect on all the other connections.

I would have no quibbles using a plastic 6mm straight push fit and some 6mm nylon pipe to extend. You'll probably have a faff getting that tight bend in the pipe and although I've not had to do it yet, I've read on here of making a simple groove...

With the blend motors, I never de-pin, I just cut the wires, solder the ends and insulate with heat shrink.

These are the bags I've ordered (Dunlop), not Britpart so hopefully they fit without an issue as thought Dunlop were fitted from manufacture of the vehicle? They haven't arrived yet, should arrive later this week, I just wanted to get the old...

Yes cant change things. As you say I will have to cut past the raised collar as the pipe up to it is now no good. Then will have to hope it can still reach. If not I will have to order some pipe and repair joints. Thanks for your help/advice...

Believe me I pushed very hard and with various screwdrivers and pulled hard on the pipe it would not budge, I spent a good 30 minutes trying on both sides. This wasn't a one try and then give up job.

So after successfully replacing one of the blend motors yesterday, today I started on what I thought would be an easier repair replacing the rear air springs as the back end keeps dropping overnight, removed the timer relay, front stays high the...

Changed the blend motor today, took me a while but glad I decided to do it. As you said Datatek no need to remove the dash which was a relief, managed to access it after removing the instrument cluster. New blend fitted and now it all works as...

Is it a job that can be tackled alone or do you need two people to get the dash out? Never attempted anything like this before but willing to give it a go over the next few weeks if the weather improves!! It will probably take me a long time to...

Only a small job !!

The ducting can be cut through the speedo aperture , i fixed it back using push bike inner tube glued so it was tight to slide up, motors can be got at then. Not done motors myself but a friend has , i cut the ducting to do the matrix seals.