steve2286w's latest activity

Sounds a bit too tinny for a propshaft. maybe exhaust clamp. Hope you're right though.

https://www.landyzone.co.uk/land-rover/injector-pump-drive-gear.385805/ Did you get the EP mark checked against the max valve lift using dti as manual says when fitted new chain As above can take a bit tinkering

Yep 5 yr guarantee, think last one did 3 years then halfords swapped it no quibble for the current one, which again has been on there approx 3 years. I always write on the battery when fitted and keep the receipts, also done this at work for...

Very good fir the silver Yuasa 5 yr guarantee?

Hi Dan Nowhere near I'm afraid , what I did with mine was to work out how much it turns as you lower the housing onto the cam gear and adjust for that , think I also turned the oil pump spindle with home made tool incase that was twisting it...

Hydraulic lock can only occur when water (or other liquid) enters the cylinder through an open inlet valve. The moment the piston commences the compression stroke the inlet and exhaust valves will be closed resulting in a bent con rod or rods...

Glad you got a resolution. Honestly i was expecting £50000 not £50

So I changed the Crank Sensor tonight and the car is running. No stops or jolts so far. I am too scared to drive it around the block because I don't want to sit there for hours waiting for a recovery van. So just running it on the drive for now...

Wasn't quite happy with putting it back together knowing the cam was stiffer than it should be. Took a razor blade to the shiney spots on the cam bearing and gently reamed it down, took a few attempts but now turns freely with only a small...

The 1.6 is very short gearing and a Tdi doesn't rev very much. I'd need to check for certain, but I'm reasonably sure a factory 130 with a Tdi would have had a 1.4 transfer box, but this would have been the tall gear-set LT-77 with the 200Tdi or...