Recent content by Spencer127
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
S
Hi all
I have a Disco 3 and a little while ago the bottom section of the boot wouldn’t open, although it would unlock and click it wouldn’t open. I resolved that by some WD40 and patience and all was fine! Now the top section is doing exactly the same but I can’t get in anywhere to WD40! When...
-
S
Hi. I have a Discovery 3 (2005). The stereo lost volume control and all sound, but all buttons etc seemed to continue working. I searched up and apparently it sounded like an “amplifier” issue, a common fault?! (Id checked fuse etc F42).
I eventually got the old amp out and bought a second...
-
S
I’ve got old amplifier out and it’s a Harmon Kardon amplifier XQK500093
If I order a second hand one will it just be a case of is fitting this in.....the breakers sites say “not decoded before removal”..... will it need programming in to my car?
-
S
Bought new fuse and replaced to be certain.... still nothing!
Still can’t see any light on amp
Is it worth getting secondhand and and replacing? Is this cheapest option?
-
S
Awww thanks for support
I’ve located internal fuse box, found F42, removed it (after eventually locating the little tweezers lol) and then dropped it! Eventually found it and put it back in to reset amp but still no sound. Presume this means amp knackered? Still can not locate a light of any...
-
S
Hi. Sorry if this sounds “girlie”, but I can’t find a fuse f42, nor a light on the amp. I’ve taken these photos in hope you can advise further ♀️♀️
-
-
S
Thank you so much for your reply. Most helpful. It’s a TDV6 SE.
IM not sure re the light... haven’t seen any light on there
It’s Harman Kardon if that helps?
-
S
hi all. Brand new here and hope this is in the right place....
I’ve a 54 plate Discovery 3 and the stereo volume has stopped working. I’ve been told it’s the amplifier that needs replacing (a common fault?!).
A brand new one is £840, but I’ve located several via breakers etc., but I need to...