Recent content by Spartan117
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
S
cheers ill check it out then. might get lucky and grab a bargain
-
S
Has anyone being to Newark auto jumble before,was their many landrover spares. I was thinking about going to the one at the end of the month and was just wondering if it's worth the trip. Their is also one at hemswell cliff in Lincolnshire if anyone has being to that.
Cheers Andy
-
S
Hi cheers for clearing that up. I've taken a pic just to be sure. Thanks for the responses, no doubt I'll be back soon with another problem. Cheers Andy
-
S
Hi all, I know this question has being asked before but I just wanted to be absolutely sure. I've put a 300tdi into my early 90 and im connecting the fuel stop solenoid but instead of their being one connector I have 3. I understand this is the "dds" unit and the cover needs taking off and a...
-
S
Cheers for clearing that up, that will keep me busy next week then. Hopefully all goes well
-
S
Hi James thanks for the swift reply. I will be fitting in the factory position as its a better job as you say. My engine mounts look different the 300tdi has a cradle type mount were one sits in another, the 2.5na just has the simple rubber blocks with mounts. Will probably fit the 300tdi mounts...
-
S
Hi which engine mounts did you use. I could use the defender mounts or use the discovery mounts,which would also mean grinding the chassis mounts off the discovery chassis. which would you recommend,cheers Andy
-
S
thanks for the quick response i understand new props etc but is their a datum point i could use to install the engine and box from.
-
S
hi all just after abit of advice, i've being looking through forums for the answer but cant find a definite answer.
i have a 300tdi and r380 to replace my 2.5na and lt77, alot of people do the upgrade but keep the old gearbox in place. id like to fit the 300 tdi in the correct place so i wont...
-
S
Guessing no one knows then
-
S
Hi, is their any difference between the front and rear propshafts for a landrover 90 with a 2.5na engine and lt77 box. I'm connecting mine back up but can't remember which is which as the truck only came with one shaft which wasn't connected.
-
S
Cheers mate,thought they looked the same. 👍
-
S
Hi,after abit of advice I've just ordered 2 discovery 300tdi calipers by accident. I wanted some defender ones. When the discovery calipers arrived they look exactly the same as my old defender ones and pads etc fit in fine. Is their any difference and will I be able to put these on my...
-
S
Hi mate were abouts are you getting the cappings and bulkhead from
-
S
Here's another picture of the rear bulkhead