Recent content by Shutts

Thanks for the advice, i think i will certainly need to strip and do some investigation. if i were to install a new 10" clutch, where can i get these from? i assume they're not available from the usual LR part suppliers, John Craddock, Paddocks etc. now comes a probably stupid question, can you...

Hi Hi there, thanks for your email about the clutch issues, still having issues where the clutch biting point is right on the floor and barely disengages the clutch. could this be a clutch issue rather than selector fork or slave cylinder? I'm trying (praying) i dont have to take the gearbox...

Could be, the slave cylinder is new (Britpart so unsure of quality) the main issue is the fact the new slave cylinder doesn't sit flush, the bell housing on the gearbox bell housing seems to protrude too much, pushing the cylinder off centre. The two photos attached are of the old slave...

Ah, sorry about that, thanks for the tip! I shall try again!

Hi Everyone, Hopefully posting in the right place now! Whoops! I've recently purchased a new project to keep my sanity at bay during this crap time. I ventured through all the usual channels and managed to land myself a seemingly intact 1973 Series 3. The bloke i bought it off didn't have a...

Thanks, great to be here!

Hi Everyone, I've recently purchased a new project to keep my sanity at bay during this crap time. I ventured through all the usual channels and managed to land myself a seemingly intact 1973 Series 3. The bloke i bought it off didn't have a clue about much, let alone Land Rovers which should...