Recent content by shanecl
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
S
Thanks coffeelandy, Yep I'm aware of them. There plans are based on mdf. This guy built it out of sheet metal, had lots of good ideas and workaround for shaping the metal, would like to read it again so as to copy him.
-
S
hi folks,
Looking for some help. I remember seeing a post on a forum either here or lr4xr where someone stuck up a link to their mate who was building a Toylander defender out of sheet metal. Thought I had saved it for later reference and now I need it and can't find it. From memory I think...
-
S
My first thought was the disc out of date but it's well in date, hope you had all the gear on. Scary when it goes pop.
-
S
Guys I have an early model defender the under the driver seat fuel tank. What are the sizes of the fuels lines, feed and return for the efi v8. Even better if someone knew the size in -6 or -8 for example. Thanks
Shane
-
S
Well the front two on mine also had a channel just no O ring as it has a seal in the axle tube.
-
S
Here you go. Rear sitting on top of front. Everything the same apart from the abs sensor wire front good foot longer
Scrap the photo. This has to be the most unuser friendly site for uploading photos. Send me your email addy if you want them
-
S
I have a disco 2 front and rear axle stripped I will place front and rears bearings beside each other and compare lengths tonight.
-
S
Between the two points where the bolts go through the the bulkhead onto the out riggers.
-
S
Just done mine, I braced the bottom of it with some 50mm angle and instructed them to allow air cool. Have a picture but can't upload for some reason
-
S
Great, thanks James. Better lay down when I get the price from pirtek lol
-
S
Hi guys,
I'm thinking of getting the brake quip lines from pirtek and they asked as a rough price what size is the pipes and the fittings that go into the flexi hoses are. As I haven't a clue anyone on here know. Thanks for any help,
Shane
-
S
Great, thanks James. Last question :) . What's the torque for the rear output shaft bolt and any trick to stop it rotating when torquing.
-
S
Thanks James. Waiting on my TC to arrive and will give it a shot
-
S
Sorry to hijack Litch but quick question for yourself or James. I'm about to install my auto box and have never done this. How do I ensure the t/c sit back. Is there a way to measure before it's installed or after. Thanks,
Shane
-