Recent content by sguilliard

I bought some new bezels, and just pushed them until they went into the bumper. The plastic of the bumped bends quite a lot, and I just used a rubber mallet to push (NOT hammer) the new sensor (already clicked into the bezel) into the bumber until it eventually went it (with quite a big push).

I used a 16mm hole boring bit (just as in the photo). You'll drill through the first part and get through a metal piece before getting into a lot of plastic. It's useful have the new sensor nearby to compare how deep you should keep drilling before you stop. I drilled all the way through to the...

I'd just like to thank the original poster, as I've just changed one of the sensors following this method, and ten minutes later (took me a little longer to prise the old one out) I now have working parking sensors again! This literally saved me hundreds! :-)