Recent content by Scrum5atk

It's a box with 2 spacer tubes,I've just done mine. I haven't found the piece made up.there is a thread about rebuilding the corners.been on recent so shouldn't be hard to find

The doors are swappable

Will do. Cheers

Cheers.it's STD/heavy duty suspension Front prop needs pulling out a couple of inch to reach the axle

How tight should a prop be to fit. As in,should the prop be as long as possible and a tight fit or should the prop be an inch or to short and slide up to the axle....? Obviously can't be to short or it will pop when off road Cheers

Not seen a bulkhead like that before

I'd replace shocks and spring and polybush. If the shocks are original lol Stick with oe unles anyone knows of any to make it more comfortable

Just buy a truck cab roof and rear panel then bolt to yr exiting tub

There isnt a bulkhesd on a few 110? U may need a filler plate to fill the gap between rear panel and the bulkhead on yr hardtop rear tub I know u did on series motors

Glubs

Think yr need a filler plate between the bulkhead and rear of cab.