Recent content by Sander

Thanks, I have found an old lamp-socket. That must be it.

yep, It's a split breaking system. Under the Servo the 2 lines ( Front- RearBrakes ) comes into the block. On that block there is a switch. If one of the two sides loses presure the switch is activated. But there is no light on my dasboard. I want to put a light somewhere, but I don't know where..

I found out that My S3 88 has a Brake Failure Switch. It is even connected ! But where should the light be on the dashboard?

Replace the pressure switch first, just to be sure. They cost about a few pounds.

If you want to check if the fuel-sender is working, get the sender out. Then measure with an Ohm-meter between the positive and the earth. It should go up/down when you move the arm up/down. Are you sure the two wires to the fuel-sender are not switched? The other wire is for the tank-emty light.

Sounds like a leaky clinder. Put a clamp on the hose after the main cylinder, then you know wether it's the main cylinder or not.

Yep, it's on the back of the speedo. A little box about 1'' x 1/2''

Hello The speedo does not work with electrics, just check out the cable and/or connections. The gauges have one common thing. The Voltage stabilizer. Check this out, or better, buy a new one. There cheap.