Recent content by Rover drive

Thank you, I found it

Off topic A member sent me a message offering to use their nanocom I hope you are reading this and thank you. I wasn’t being rude and not replying I just can’t see where on here that has the message I got an email notification Thanks

Thanks Mate sent me that tip earlier I have just finished checking that, It appears it could be there, as connecting and disconnecting that connector makes needle move to end of blue. So I will clean properly

Haha whoops thanks

Ok thank you Sorry what’s IIRC

Ok thank you

Ok will check that, but with what’s happening in the world atm I doubt that I would see it quickly. Keep it in mind, what was last sentence about £50 a shot? Does nanocom only do one car?

No problem even if I was in a colder climate I would like the temp gauge working especially when usually a overheated 4.6 ends in catastrophe. I wonder why now is it because people think that the temp gauge as irrelevant that you see so many P38 with stuffed motors? Hopefully someone has some...

Turning the heater on in Australia’s summer instead of fixing the guage? That’s the dumbest idea sorry. As I have said sensor has been changed, the old one was also put in other car and it works fine. Was hoping some one had struck this before and had some pointers. Unfortunately don’t have...

No it is not. Have used infra red temp guage pointed at top hose outlet in manifold. Reads average 95 degrees, so if guage was working it should have at least gone into blue zone

Ok thank you. I thought that would be the case

Or should I try swapping bcm and cluster together from another 97 That would tell if it’s wiring issue or not Or will that cause havoc with immobiliser

I have access to a 2001 cluster will that still work in my 1997 Thanks

Ok I have swapped sensor from another 97 that’s working correctly Same result I don’t have nanocom I wasn’t game to swap cluster in case the kms change or worse Cause car to immobilise Thanks

Hi hoping someone can help The temp gauge on 1997 4.6 HSE goes to beginning of blue section when ignition is turned on. Once car has been started and well and truly warmed up the guage has not moved at ALL Even removing wire from sensor makes no difference or grounding sensor wire The reading...