Hi,
after surfacing my heads (to clean the old gasket marks) i found these measures :
23,30 mm (+ 0,1mm / 0,5 mm max. skimming )
62,80 mm ( + 0,2 mm / 0,5 mm max skimming)
Should i put a thiker composite gasket instead a metal one ?
the gap can...
the heads were already skimmed 10 years ago.I check with a plate and 0,05mm gauge, seem ok.
i have to sand the inlet manifold too...
should i stay with 400 paper or finish with 800 ? i have a metal gasket.
Thanks.
the old seal has left marks...do i need to remove all before setting new gasket ?
I use sand paper on a glass to remove these marks but i dont want to remove too much material;
Is that enough like this ?
Plus, I notice i remove more on the sides...
The shells seems to be good enougth (colour effect for the bronze) as the rings!
I follow the manual for the oil ring : Position the oil control piston rings so that the ring gaps are all at one side, between the piston pin and piston thrust...