roger01's latest activity

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  • roger01
    Hi, I am following the thread as I am having a similar problem, with a 2.5 dsl, out of interest, which Kingbolen Ediag do you use the Elite or the yearly subscription one
  • roger01
    roger01 replied to the thread 2000 RPM max.
    Thanks for the input guys, no sign of external intervention, had all the pipework apart so no probs there, the diesel is no more than 6 months old as I replaced the in tank pump September last year, I have just purchased a Nanocom on fleebay, I...
  • roger01
    roger01 replied to the thread 2000 RPM max.
    Hi all. to continue, the MAP gives out 1.8v at tick over this rises to 2,19 - 2.2v at 2000 RPM, tried a new sensor (Lucas) no difference, put in a couple of pressure test tapping points, the Turbo kicks out around 0.2 PSI at tick over this rises...
  • roger01
    roger01 replied to the thread 2000 RPM max.
    Hi only going on various threads I have red and several mention 12v supply and a max 5v back on the signal line, but thinking it through if a sensor went sc with a 12v supply then you would get 12 back into the sensor input which I doubt it would...
  • roger01
    roger01 replied to the thread 2000 RPM max.
    Hello again, lifted the ECM out and tested from the plug/connector (C0411) to the MAP plug, continuity 0.2/03 ohms including the test leads so no probs there but still only 5.4 volts when I plugged it all back in, tried a temp 12v to the MAP...
  • roger01
    roger01 replied to the thread 2000 RPM max.
    Hi everyone, sorry for the long delay but close family health issues over the past few months put this on the back burner, so had all the Turbo pipes off, intercoler clean, all ok Turbo blows a storm etc., still 2K max revs but now found the...
Back
Top