Recent content by robertf

It looks like the power and bcu supplied ground for dome lights is ran up by the right side alpine window to a header and everything splits from there. That would be the cleanest point to tap into using the switch directly would be unreliable. It wouldn’t destroy anything other than maybe...

Thanks, but Ive got the 300tdi snorkel so I know what that looks like. I need an install video for a 200tdi

I am unable to find pictures of a 200tdi mantec snorkel so Im hoping someone here knows the difference. Is it the length where the tube runs down the fender? And are the brackets in the same position? Bonus points if someone knows if the 300tdi camel trucks used the 200tdi snorkel to fit the...

GEMS V8? If so this should do it with an android device and elm327 bluetooth module https://play.google.com/store/apps/details?id=com.flemcodesign.gems.gemsutility Nanocom should be able to do it as well on any engine with the right licensing

Immobilizer synch with android and elm327 https://play.google.com/store/apps/details?id=com.flemcodesign.gems.gemsutility

maybe your cousin needs to watch this.

Mostly the same. Earlier defenders had wider bearing spacing in the hub, longer stub axle, different drive flange, slightly different locknut washer. Earlier than that a different bearing combo was used but that may have been series 3. Ive read later stuff changes bearings and lock nuts, but...

Haven’t had any bearing failures with 35s and offset wheels. are you greasing them, or relying on no inner seals and gear oil?

Sounds like power supply is being interrupted. This is a 3.9 and not 4.0, right? Clean up the underhood fusebox of any corrosion and replace the main relay. Its a metal cased dual pole single throw relay. There are 2, one is main ecu power and the other is fuel pump relay. They are in the...

bumping an old thread... Don't have access to a TD5, but I've recently done some GEMS communication work and it looks very similar If you can't get a cheap elm327 module working, I'm sure you can get it working with this one https://www.scantool.net/obdlink-lxbt/ If someone has an elm327...

Here's what I use for my switches http://www.shapeways.com/product/BQFD8MQ86/land-rover-discovery-carling-switch-bracket?optionId=59688376

Yes

You unplug the cd changer and plug this in its place. They all have the round plug at the radio end. 95 should have a rectangular end at the cd changer side while older ones use the round 13 pin at the cd changer end.

Hey that's my pic. So I'm guessing you found the website for the aux cd changer replacements. I love the one in my disco, but I'm a bit biased as it's my product. It's not a do it yourself project since there's a serial protocol handling the behind the scenes stuff along with a NLA 13 pin...

I designed a bunch of panel replacements for this. They are here. http://www.shapeways.com/shops/fhsolutions I put the coin holder on on thingiverse.