Recent content by Rob3104

Yes checked the battery was connected ok. Failed to start yesterday so can't be charging the battery

Any thoughts please?

Experiencing a problem with my defender 300tdi. When driving the the battery light is dimly flashing. At the same time there seems to be a slight power surge to the driving lights and heating fans. I'm guessing it's an alternator problem and I am planning on changing it. Before I rush to part...

I’ve got 7.50 x r16 Avon Range Master tyres on freestyle alloys. I think this is an old style tyre size? I want to change for a general grabber style tyres. What tyre size should I be buying?

so is a CCA of 570 too low?

Following my landy (300Tdi) not starting on Sunday AM I’ve had my battery on trickle charge but it does not seem to be holding the charge. I’m guessing it’s knackered. The battery that’s currently on is 60amps (CCA SAE 570amps). Am I right is saying that it’s not the correct battery...

Thanks for the tip but I don't have any kids!! :) Anyway, for the record it's a M3 bolt/screw. I gone with allen key head so it far easier to put in and get out without having to totally take apart the door innards. Thanks for your help chaps!

Thank you. I dont really want to get get a new handle @ £15 just to use the screw!

Hi, I need to get a part for my 90. I think it’s call the locking Barrel Lever. All I really need is that small retaining screw. See the picture. Does anyone know the part number please? In this picture it’s the part number 10 which I think is the locking Barrel Lever. I’ve highlighted the screw...

I have a 300Tdi and when I switch the engine on the dashboard engine temp gauge goes straight to the red area. However as you start moving, and assuming the engine is getting air circulated, the temp reading drops immediately below half way. I’ve checked the coolant levels which are OK and the...

I’ve been experience some issues with the my 300 Tdi starting. It turns out my braided fuel hose pipes have perished. Obviously I’m looking to replace. My questions is should I just buy a length of house and simple push the hose onto the connectors as it is now: LAND ROVER 1/4INCH 6MM ID...

No, i was just want to fit a new barrel to the existing lock. even after drilling the lock I'be not been able to turn the barrel to show the brass button. anyway, I've ordered a new lock today:mad:

I tried to drill out the lock as suggested yesterday but unfortunately the bottom part of the lock sheared off. Whilst the lock now turns it’s still not exposing the little brass button you need to press to release the remains of the barrel. I suspect I’m going to need to buy a new...

Yes can't press the release button.

You mean drill the front of the lock out? How will this release the barrel?