Recent content by Richy Payne

Ok, so thanks for the help so far. I have installed a new master cylinder and bled everything through again. Symptom’s basically remain the same. With the engine off (no servo) I get pressure held on the pedal. Engine on and servo operative, pressure on the pedal and it slowly drops to the...

Thanks Pawl. The only concern I have with that is that the máster cylinder was fine before I replaced the callipers. I did have a conversation with a contact who owns a few Disco’s who suggested that it may be air in the brand new callipers that’s trapped and is notoriously difficult to...

That’ll be 2Ltr of fluid, not cloud by the way ha ha

Hi folks, got a bit of a challenge that I’m hoping one of you fine people would be able to help with; Replaces all brake lines, callipers and disks/pads on my 2002 D2 Td5. I have bled the lines in correct order (FL / FR / RL /RR), then modulator bleed in order on each line with Nanocom...

Ahh, interesting; the battery is 11.71volts and is a one year old odyssey so I think I might put it on charge for a bit and try again. I'll check that fuel pressure too though.... Thanks, Richy

Thanks Sierrafery for the response and guidance. I can hear the pump but I do need to perform a pressure test (I need some kit for this - any suggestions on adequate kit for the job?). Getting to grips with using the nanocom so I can confirm the throttle voltages seem to operate correctly and...

Afternoon all, hopefully a bit of help and advice to get my 2002 D2 TD5 going again. Driving home a while ago the engine cut out and wouldn't start. Being without my Nanocom at the time I tried changing the crank sensor (no change) and then the injector loom (still no change). Got my Nanocom...

Thanks David, I'll copy and paste now, thanks. Richy

Apologies, should have added - its a TD5 on an 02 plate....

Afternoon all, hopefully a bit of help and advice to get my D2 going again. Driving home a while ago the engine cut out and wouldn't start. Being without my Nanocom at the time I tried changing the crank sensor (no change) and then the injector loom (still no change). Got my Nanocom working...

Nice one Thanks Neil, I’ll take a look at GLASS this aft. As for budget, I can probably go 3 or 4K as a starter without getting my nether regions chewed off by the boss in doors. I’ve seen a few moded Disco’s around that price waxing lyrical about all the welding being done, sliders...

Morning all, Just joined the Landyzone community and looking forward to learning more about the world of the Land Rover and those that drive them. I am still looking to get my first off roader to go green laneing - something I’ve wanted to do for ages and reached that point of “**** it, if I...