Recent content by Range0815

Hello, i find the problem, why my valve block don't work well. My Range was jumping in the front. The next time i will buy an new valve block and hope that the jumping is gone! Remember i change all parts of the eas system, without the ventilblock! The valve seat of the middle non return valve...

Hello, my V8 4,6 engine, built in 2000 is dead. Headgasket or porus block. I like to buy an stripped engine from turner engineering. Has someone the engine with the: Option - gasflowed performance heads fitted and: Option - H180 'Sports Torque' camshaft fitted to either option* I need some...

Hello, my V8 4,6 engine, built in 2000 is dead. Headgasket or porus block. I like to buy an stripped engine from turner engineering. Has someone the engine with the: Option - gasflowed performance heads fitted and: Option - H180 'Sports Torque' camshaft fitted to either option* I need some...

Hello, don't forget: after changing: * Air suspension valve block o- rings * Air suspension valve block diaphragm * Air suspension dryer * Air compressor * All air springs * Air suspension air pressure switch * both front height sensors i do last week , not the first time, the recalibration...

Hello, i will change, because my EAS system makes trouble, the Drive Box, the Air suspension ECU and the Air suspension Delay Relay for my RR P38. Should i put the battery out of the car? Can i put then my old parts out and then the new parts into the Range Rover? I'm a very bit fearfully...

Hello, my local Landrover dealer tell me today, that it is normal when the range goes up and down. The eas system is ever working when the truck is running. Regards Range0815

Hello again, thanks for your answer. I will search. The jumping is: compressor is running some seconds, than, the compressor is still running, the range goes up in the front. After some seconds the compressor stop his working and the range goes down. After a little while it starts again...

@Datatek Hello, what do you mean with: or the driver pack is playing up? Regards Range0815

Hello, the Range goes in every high level a littel bit up and down, only at the front! The compressor is running shortly than. this will happend ever and ever after a short time. some minutes. There are no faults. Both front hight sensors are new. When i open one door the symtom stops. Or when i...

Hello, after changing: * Air suspension valve block o- rings * Air suspension valve block diaphragm * Air suspension dryer * Air compressor * All air springs * Air suspension air pressure switch * both front height sensors i do yesterday, not the first time, the recalibration with the eas...

Hello, to change the seal- crankshaft front oil ERR6490. Do i need one or two seals? Someone tell my one in the coverplate and one in the block. Is that true? Regards Range0815

@ Wammers Thank you very mutch for the information. Regards Range0815

Hello, is it possible to change the bearing of the electric engine in the eas compressor. i mean the bearing at the end, were the cabels goes in. If yes, where can i buy the bearing? Regards Range0815

Hello, today i have changed the shock absorbers of my range and see, that the front and rear diffs are leaking. What is the best way to repair? To take an diff flange and seal kit like this: Range Rover P38 Diff Flange & Seal Kit bei eBay.de: Land Rover (endet 06.03.11 16:45:25 MEZ) or only...

Hello, yesterday i have cleaned the yellow line at the rear air bags (look photos). There was some dirt from the last greenladings. Now my range goes down over night 1,..cm. Wammers inform my, that an sinking of 15mm/ 24 hours can be. I feal happy now and thanks to all for the tipps and...