Recent content by peter8315
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Thanks for that, it would be bit to far for me, as in derbyshire
-
Ok mate I’ll do that, will probably end up buying a new one though.
-
-
-
As above, or rolling, thanks.
-
Hi mate, have checked fork and retaining bolt, all tight, so I am taking gearbox out and trying one I have found in my store, it seems to get all gears, but going to put in with a couple of bolts and try it.
-
Thanks for that I am in the process of checking the fork status on the reverse shaft,I was hoping James Martin might see this thread.
-
I have checked the reverse shaft stop bolt and that’s ok, but I will check the selector fork position tomorrow, thanks for your advice.
-
Yes
Hi Terry, has it got a good gearbox?
-
Hi thanks Col, I think I have a bearing gone, as it grinds in reverse
-
as above looking for engineer or competent person to sort my series gear box within Nottingham / derby area, will take gearbox to them,
-
Well still got nowhere with this thread, thanks for your input, but I think Wireman is pointing me in the right way, and is it easy job to change bearing on reverse shaft end, I think the bearing has collapsed allowing cog to partially slip.
-
Hi mate, have found the bolt that you referred to and it ca be adjusted by loosening the lock nut on it, I have tried adjusting it in many positions but still grinds,
-
Ok mate, just got around to it, so I’ll heck that out, thanks, Pete
-
Hi mate, is that on the gate, just under gear lever