Recent content by Pete Dunbar
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
P
What are the best obd readers to get for the freelander 2 for a reasonable price?
Are the iCarsoft LR V2.0 any good for fault finding and clearing faults? Cheers Pete
-
P
Hi, as you have been very helpful before, can you please advise on this fault I have ph my 2013 Freelander 2 SD4.
The top hose connecting to the hard plastic down pipe has blown off twice. After refitting it yesterday it blew off again after only a few miles. I know it’s a fiddly job but I...
-
P
The top hose connecting to the hard plastic down pipe has blown off twice. After refitting it yesterday it blew off again after only a few miles. I know it’s a fiddly job but I thought I’d pushed it on securely but obviously not!
Is there any special ways / tricks in refitting it correctly? I...
-
P
Sorted, You can buy just the cap. I’ve had a new original one off eBay £12 👍
-
P
Have I got to buy a compete handle?
-
-
-
P
Hi, I’ve got a 63 plate freelander, what do I need to make this right, I’ve lost part of my handle. Are you able to just buy the end cap or do you have to replace the complete handle? Anyone on here have one or know where to find one please? Cheers Pete
-
P
Hi its a 63 plate XS SD4.
-
P
Hi my freelander 2 screen has gone blank white a couple of times now, then clears when you knock it off and back on. Is it on its way out? Anything I can do? Cheers Pete
-
P
Hi all, after a few short test drives over the last few days it will drive perfectly for a few miles, then go into restricted power when slowing down. But recently on the last couple of drives it seems to be in restricted power but no lights coming on? Then it’s seems to going up to about 2500...
-
P
What’s required for this procedure?
-
P
I’ve spoken with a Land Rover garage specialist and he thinks it’s still a turbo/actuator issue?
I find this difficult to understand, because when it’s going its boosting really well and pulling like a train until it idles and then goes back into restricted power??
-
P
Yes, air path calibration done?
-
P
Yes the boost pipes, some have been replaced and the others have been thoroughly checked and are all good. I’ve replaced the throttle body and turbo, which was checked before fitting. These have all been programmed to the vehicle.The turbo is boosting fine. I can clear all the codes, take it out...